User manual BERNEX BN22102 CATALOGUE 2010

[. . . ] Changes are periodically made to this document. Changes, technical inaccuracies, and typographic errors will be corrected in subsequent editions. Document version 1. 0: January 2012 Table of Contents 1 Introduction Card Readers and Card Types . . 8 2 Preparation Server Specifications . [. . . ] Check the Time Zone is set to the correct option for your region. The device will reboot to apply the changes. The sign in front of the number is important. Most of Europe is plus of Greenwich Mean Time, while North America is minus. Please consider the implications of Daylight Savings Time when selecting the Offset of Local Time Zone option. • If Network Time Protocol is not available, check that the time set on the device matches the network time on the Domain Controller Authentication Server. Refer to the System Administrator guide for instructions. If using Network Time Protocol (NTP) do not change the time on the device. Notes: • 3. 4. Configure the Smart Card Inactivity Timer a. Select Smart Card Inactivity Timer Edit. . . Enter the Smart Card Inactivity Timer minutes required between 1 and 120. Note: The ferrite bead should be clipped onto the cable directly behind the connector. 20 Xerox® Smart Card Installation Guide Installation 4. Attach the fasteners to the card reader device • Fasteners have been provided to secure the card reader to the Xerox device. • Peel back the fastener backing strip. • Position the fastener on the under-side of the card reader, as shown. • Repeat for each of the fasteners supplied. Xerox® Smart Card Installation Guide 21 Installation 5. Remove the fastener backing strips When all the fasteners have been attached to the card reader, remove the backing strips on each of the fasteners. 22 Xerox® Smart Card Installation Guide Installation 6. Place the card reader on the Xerox device • Gently place the card reader on the device (do not fix in place at this point). • Position the card reader in a suitable location, ensure it does not obstruct any access points or the opening of doors or covers. • Check the cable has sufficient length to connect to the rear of the network controller. • Once it is in a suitable location, press firmly on the card reader to fix it in place. Xerox® Smart Card Installation Guide 23 Installation 7. Connect the card reader to the Xerox device • Insert the USB connection into the slot provided on the rear of the network controller. • Use the cable ties provided to ensure the cabling is neat and tidy. The hardware installation is now complete. 24 Xerox® Smart Card Installation Guide Installation 8. Confirm the installation • When the card reader and the software has been installed and configured, the Card Reader Detected screen displays on the Xerox device local user interface. • Select OK. Smart Card is now ready for use. Note: If the card reader is not detected, refer to Troubleshooting Tips on page 29 for information. Xerox® Smart Card Installation Guide 25 Installation Using Smart Card Once the Smart Card has been enabled, each user must insert a valid card and enter their Personal Identification Number (PIN) on the touch screen. When a user has finished using the Xerox device, they are then required to remove their card from the card reader to end the session. [. . . ] • Verify that the date and time and GMT Offset (Time Zone) is correct, refer to Configure the Date & Time to update automatically on page 14 for instructions. • Verify that GMT offset is correct for Daylight Savings Time. • Contact your System Administrator. • Check the IP Address printed on the configuration report. [. . . ]