User manual BERNEX BN22307 CATALOGUE 2010

[. . . ] Press the button again to cancel the option. The drying programme is started by pressing the "Start (Pause)" button. Changing programme selection: If the programme selected is changed during drying, the dryer stops. To operate the new programme, again press the "Start (Pause)" button. [. . . ] For your safety the drying cycle stops automatically if you open the door. To restart, after door opening, close the door and press the "Start (Pause)" button again. Warning: Never stop a tumble dryer before the end of the drying cycle, unless all items are quickly removed and spread out so that the heat is dissipated. The final part of a tumble dryer cycle occurs without heat (cool down cycle) to ensure that the items are left at a temperature that ensures that the items will not be damaged. Sort laundry according to care symbols: Do not tumble dry Suitable for tumble drying at low drying temperature Suitable for tumble drying Preparing laundry Opening door Loading dryer Selecting programme Selecting options (if available) Starting dryer Programme end unloading dryer End: Take the laundry out of the dryer. The drying process is complete and the anti-crease phase has been reached (active). Anti-Crease: If the laundry is not removed at the end of the drying cycle, an automatic anti-crease cycle will operate for maximum 60 min. The drum rotates at regular intervals to prevent the laundry from creasing. Set the programme selector knob to " ". Cleaning the lint filter: Open door, pull lint filter up and out of machine and open it. Brush lint using a soft brush or your fingertips. Close lint filter and push firmly back into place. · If the drying result does not meet your expectation, select a more dry programme. · Is the plug properly inserted into the mains electricity socket?· Has a drying programme been selected?· Has the "Start (Pause)" button been pressed?· Has the start delay option been selected?· Has the water container been inserted correctly?· Has the heat exchanger been inserted correctly?· Has any fluff on the heat exchanger seal been wiped away?· Has any fluff on the door seal been wiped away?· Has the water container been inserted correctly? AFTER-SALES SERVICE If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the machine off. Please contact your after-sales service representative (for more information, refer to the warranty manual). [. . . ] · The service code (the number after the word Service on the adhesive rating plate) on the right-hand side when the door is open. 3 Before using the machine, please also read the instructions for use carefully! AWZ 7913 Quick Reference Guide GB Programme selector knob The drying programme is selected by turning this knob. Programme sequence + "Start (Pause)" button The drying programme is started by pressing this button. The indicator lamp flashes during the selection phase and lights up during drying. Overdry protection Drying Anticrease End of cycle Indicator lamps Filter The indicator lamp lights up when the filter and/or heat exchanger need cleaning. Clean the filter at the end of every cycle. Options Gentle Reduces drying intensity (recommended for delicate items). Water container The indicator lamp lights up when the water container needs to be emptied. The drying cycle is automatically interrupted. [. . . ]