User manual BERNEX BN22602 CATALOGUE 2010

[. . . ] 55 AVAILABLE ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58 USING THE COOKING HOB. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 62 USING THE OVEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 68 OVEN FUNCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The module will try to maintain the maximum possible power levels supplied and the levels imposed by the automatic management will appear on the display. The flashing of a power level indicates that it will automatically be limited to a new level selected by the power management module. Priority is given to the last zone set. 6. 13 Control lock The control lock is a device that protects the appliance from accidental or inappropriate use. With all cooking zones turned off, simultaneously turn the first two knobs to the left (position "A"). Keep them turned until the symbols appear on the display, then release the knobs. In order to remove the control lock repeat the same operations previously described. If the knobs have been kept rotated in the "A" position for more than 30 seconds a fault message will appear on the display. After a prolonged power failure, the control lock will be deactivated. If this is the case, turn it back on as described above. 67 Instructions for the user 7. USING THE OVEN 7. 1 · Before using the appliance Remove any labels (apart from the technical data plate) from trays, dripping pans and the cooking compartment. · Remove any protective film from the outside or inside of the appliance, including accessories such as trays, dripping pans, the pizza plate or the base cover. · Before using the appliance for the first time, remove all accessories from the oven compartment and wash them as indicated in "9. Five seconds after last pressing the key the countdown begins, at the end of which the buzzer activates. The current time can be viewed during the countdown by pressing key once, press the key again to return to the timer display. 2) At the end of the countdown the oven must be stopped manually by turning the thermostat knob and the function selector knob to 0. It is not possible to set a cooking time of more than 4 hours. 71 Instructions for the user 7. 7. 3 Programming Cooking time: the 2nd key can be pressed to set the cooking time. Before it can be set, the thermostat knob must be turned to the required cooking temperature and the function selector knob to any setting. To set the cooking time, proceed as follows: · Press key ; the pointer will go to position 12 will flash (Fig. or to set the 1) and the adjacent symbol · Within 5 seconds press key · cooking time: each pressure on adds 1 minute to the cooking time, and every 12 minutes a new inside segment will light up (figure 2 shows a cooking duration of 1 hour); Once the required time is obtained, cooking will start about 5 seconds after the last pressure on . The display will show the current time, represented by the constantly illuminated segments, and the minutes left to the end of the cooking time, represented by the flashing segments (each flashing segment means 12 minutes of cooking time left). At the end of the cooking time the timer will switch the oven heating elements off, the buzzer will start to sound and the numbers on the dial will flash. The time can also be reset by deleting the program selected: Press the central key for 2 seconds to cancel the set time and the oven will have to be manually switched off if the cooking operation is in progress. or · 2) · · It is not possible to set a cooking time of more than 12 hours. 72 Instructions for the user Cooking start: as well as setting a cooking time, the cooking start time can also be set (with a maximum delay of 12 hours in relation to the current time). To set the cooking start/end time, proceed as follows: · Set the cooking time as described in the previous point. [. . . ] Specific instructions for each operation of this kind are given below. Before any intervention that requires access to live parts, disconnect the appliance from the power supply. If a problem cannot be resolved through ordinary maintenance or in case of other types of fault, contact your local technical support centre. 10. 1 Replacing the light bulbs Remove the bulb protector A by turning it anticlockwise and replace bulb B with a similar one. Use only oven bulbs (T 300°C). 88 Instructions for the user 10. 2 Removing the door Open the door completely. [. . . ]