User manual BERNEX GB11116 CATALOGUE 2010

[. . . ] Note: We recommend that you operate the Vb 800/1000 in conjunction with our Velocity series amplifiers. The Vb 800/1000 can be operated in normal as well as in bridged mode (for further details, please refer to the operating instructions that came with the amplifier). In any case, please observe the RMS output power of your amplifier. [. . . ] It must not exceed the RMS power of the Vb 800/1000. In order to achieve a balanced sound, we recommend that you configure the amplifier as follows. First set the volume control to minimum and the crossover control to its middle position. Now play some music on your car sound system that you are very familiar with and that contains some low bass (e. Now slowly increase the volume of the subwoofer until you feel that the sound of the music is well balanced, i. The bass is neither too weak nor overpowering. Now listen to the relationship between deep male voices and the upper bass and also take note of the relationship between the upper bass (kick bass) and the lower bass. The bass should ideally sound crisp and have a clear low bass component, and male voices should neither sound too weak nor should they billow out. If you are happy with the sound then you are already finished with the setup process. Now listen to the relationship between deep male voices and the upper bass and also take note of the relationship between the upper bass (kick bass) and the lower bass. The bass should ideally sound crisp and have a clear low bass component, and male voices should neither sound too weak nor should they billow out. If you are happy with the sound then you are already finished with the setup process. If male voices seem to billow out or the low bass is too weak, you should turn the crossover control slightly towards minimum and then resume making your adjustments as described in point 2 onwards. If the bass sounds low but dirty and booming or the male voices sound too weak, you should turn the crossover control slightly towards maximum. Furthermore, you should set the phase control (if present) so that the upper bass sounds as powerful as possible. Next, resume making your adjustments as described in point 2 onwards. USA General Please read these operating instructions before using the equipment for the first time. We provide a manufacturer guarantee for our products bought within the United States of Amerika. [. . . ] We provide a manufacturer guarantee for our products bought within the United States of Amerika. The warranty terms can be called up under www. Installation and installation instructions Disconnect the negative terminal of the battery before carrying out installation and connection work. [. . . ]