User manual BERNEX GB11438 CATALOGUE 2010

[. . . ] We wanted to offer you a product of excellence. In the BERNEX product range, you will also find a wide choice of hobs, ovens, microwaves, hoods, cookers, fridges, freezers, that you can coordinate with your new BERNEX dishwasher. Visit our website www. dedietrich-electromenager. com, where you will find our latest innovations as well as useful and complementary information. BERNEX Setting New Values As part of our commitment to constantly improving our products, we reserve the right to make changes to them based on technical advances to their technical and functional features and appearance. Warning : Before installing and using your appliance, please carefully read this Guide to Installation and Use, which will allow you to quickly familiarise yourself with its operation. 33 EN 1/ FOR THE USER’S ATTENTION Keep this user’s manual with your appliance. [. . . ] Place large diameter dishes and pans at the sides. Do not intersperse, jam together or superimpose flat plates and concave dishes (Fig. The folding spikes make it easier to arrange your large dishes (Fig. 09) (depending on the model). When you re-insert the lower basket, ensure that nothing catches on the upper basket’s gauge wire to avoid blocking the rotor. Unloading your items First of all empty the lower basket to avoid drips from the upper basket falling onto the lower basket. Advice : Fig. 09 44 EN 8/ YOUR DISHWASHER’S EQUIPMENT • THE UPPER BASKET This basket is particularly designed to take: glasses, cups, ramekins, small salad bowls, bowls, saucers, etc. . . Arrange your items methodically to save on space (arranging glasses, cups or bowls together, etc. ) You can also arrange cups, ladles, etc. 10) Position the cavities of glasses, cups or bowls facing downwards. Cutlery basket Advice : Fig. 10 • Adjusting the height of the upper basket (depending on the model) For large dishes to be loaded in the lower basket, the upper basket must be set in to high position. This can be done with the basket fully loaded (Fig. 11) ① Setting in HIGH POSITION : Gently raise your basket on each side until it engages. Fig. — Access the setting by holding down “Set” juntil you hear a double audible signal (long beep). Select your preference by pressing the “Delayed Start” button E : - Beep activated : an audible signal is heard and the “End” light flashes. - Beep de-activated : no audible signal and the “End” light is unlit. The setting is confirmed automatically after approximately 10 seconds. A short audible signal (beep) confirm the button’s selection, except for the “On/Off” button. • Delayed programme start After selecting your programme, press the “Delayed Start” E button once twice or three times depending on whether you wish to delay the programme start by 3, 6 or 9 hours; the appropriate light illuminates. Confirm by pressing “Start/C”. • Cancelling a programme C” F button for a few Hold down the “Start/C seconds. 50 EN 12/ CLEANING YOUR APPLIANCE • CLEANING THE WASTE FILTERS The filtration system consists of several elements: A - The waste filter. The filters are located in the centre of the tub and must be washed regularly to obtain optimum washing results. ➀ A B C ➁ • Actions : Before removing the filters, remove any waste on the large main filter B with a sponge so that the waste does not block the sprinkler arms. Orient the rotor as shown in the drawing. 14) ➁ Loosen the waste filter a quarter of a turn and then remove it A . ③ Remove the main filter B . ➀ A ③ B ④ Remove the micro filter screen C . ④ C ⑤ Carefully clean filters Reinstallation: A , B and C Fig. 15) ⑤ Proceed in reverse order, inserting filters C and B and then A . A B C Remember to lock the waste filter in A place by pushing it in fully and turning it a quarter turn. Important : Fig. [. . . ] Poorer drying on rapid programmes - On rapid programmes, the drying - Select a rapid programme temperature and drying period are carefully or leave the door ajar reduced to cut down the duration for a few minutes. of the cycle as much as possible. Condensation on the wall of the - Condensation may form on the inside door or the tub. walls, particularly after the appliance has cooled down (sound insulation increases the phenomenon) 57 EN 14/ AFTER-SALES SERVICE • INTERVENTION WORK Any intervention work on your appliance must be performed by a qualified professional approved by the manufacturer. When you call, please mention the full reference for your appliance (model, type and serial number). [. . . ]