User manual BERNEX GB31103 CATALOGUE 2010

[. . . ] Documentation Classifications In order to assist in the use of this product, BERNEX provides the following types of documentations:  For quick set-up of the product, read the Quick Installation Guide included with the product. ρ® For detailed product information, carefully read the User's Manual. For product-related information, check on our website at: http://www. Com Identifying Your Motherboard Revision The revision number on your motherboard looks like this: "REV: X. [. . . ] This mode is similar to Auto, but it adds the capability to route the ports to xHCI or EHCI according to setting used in previous boots (for non-G3 boot) in the pre-boot environment. XHCI controller enabling and rerouting should follow the steps in Auto, when previous boot routs ports to EHCI. Note: This is the recommended mode when BIOS has xHCI pre-boot support. (Default) Auto BIOS routes the sharable ports to EHCI controller. Then it uses ACPI protocols to provide an option to enable the xHCI controller and reroute the sharable ports. Note: This is the recommended mode when BIOS does NOT have xHCI pre-boot support. Enabled All shared ports are eventually routed to the xHCI controller during the BIOS boot process. If BIOS does not have pre-boot support for the xHCI controller, it should initially route the sharable ports to the EHCI controller and then prior to OS boot it should route the ports to xHCI controller. Note: OS has to provide support for the xHCI controller in this mode. If the OS does not provide support, all sharable ports won't work. 0 ports are routed to the EHCI controller and the xHCI controller is turned off. Set this item to Enable when a TPM device is installed. 0 Controller, R_USB30_1 ports on the back panel) & OnBoard LAN Controller#1 Enables or disables the Etron EJ168 USB 3. (Default: Enabled) If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to Disabled. Specifies the operating bandwidth for the PCIEX4 slot. Auto Lets the BIOS automatically configure this setting depending on the expansion card being installed. All PCIe x1 and PCI slots will become unavailable when a PCIe x4 expansion card is installed. & PCI Express x4 Slot ` Super IO Configuration & Serial Port A This section provides information on the super I/O chip and allows you to configure the serial port. (Default: Disabled) BIOS Setup - 52 - 2-7 Power Management & AC BACK & Power On By Keyboard Determines the state of the system after the return of power from an AC power loss. Always Off The system stays off upon the return of the AC power. (Default) Always On The system is turned on upon the return of the AC power. Memory The system returns to its last known awake state upon the return of the AC power. [. . . ] Turn off the computer and connect the hard drive(s). Check if the system can boot successfully. Reinstall other devices one by one (install one device at one time and then boot the system to see if the device works successfully). END If the procedure above is unable to solve your problem, contact the place of purchase or local dealer for help. [. . . ]