User manual BERTAZZONI DH1026

[. . . ] The installation of this appliance must conform to local codes and ordinances. If local codes permit, a flexible metal appliance connection with the new AGA or CGA certified design, max. Do not bend or damage the flexible connector when moving the cooktop. The pressure regulator has ½" female pipe thread. [. . . ] ) Maximum depth for the overheads cabinet is 13" (330mm) 2. Side clearances (Minimum values) The different side clearances shall be in accordance with the minimum values indicated in the table n. 1- 2 The cooking surface area is defined as that part of the appliance where cooking normally takes place and does not include those parts of the appliance containing control knobs. Clearance between the front edge of the appliance and the front edge of the cabinet. Clearance between the left/right side edge of the appliance and the side wall (if present). Clearance between the back edge of the appliance and the back wall. To prevent liquids from leaking accidentally into the underlying storage space, the appliance is equipped with a special gasket. To apply this gasket, carefully follow the instructions in Fig. Lay out the protective sealing strips along the edges of the opening in the bench top and carefully overlap the strip end. With a screwdriver assemble the brackets A to the hotplate bottom by means of the screws B. Slide the hooks into position and secure them with the screws. ATTENTION: An exhaust fan may be used with the appliance; in each case it shall be installed in conformity with the national standards in force. ATTENTION: Exhaust hood operation may affect other vented appliances; in each case it shall be installed in conformity with the national standards in force. Before carrying out any maintenance work, disconnect the appliance from the gas and electric supply. - CHANGING THE NOZZLES FOR USE WITH OTHER TYPES OF GAS: To change the nozzles of the burners use the following procedure: Lift up the burners and unscrew the nozzles ( Fig. 7) using an adjustable spanner of 7 mm and change the nozzles with those designed for the new gas supply according to the information given in TABLE A shown below. TABLE A: Adapting to different types of gas Drop-in cooktop with 5 workyop burners model B3W0. Drop-in cooktop with 6 workyop burners model B3Y0. CAUTION: save the orifices removed from the appliance for future use Regulation of the "MINIMUM" on the burners To regulate the minimum on the burners carry out the following procedure indicated below: 1) Turn on the burner and put the knob onto position MINIMUM ( small flame ). 3) Beside the tap bar on the work top, insert a small slotted screwdriver into the hole on the vale rod (Fig. 8) and turn the choke screw to the right or left until the flame of the burner is regulated in the most suitable way to MINIMUM. 4) Make sure that that the flame does not go out when changing the position quickly from MAXIMUM to the MINIMUM position. [. . . ] For safe use of appliance, do not use it for space heating. Do not use aerosol sprays in the vicinity of this appliance while it is in operation For description of hotplates refer to installation instructions. A diagram is etched on the control panel above each knob which indicates which burner corresponds to that knob. Manual ignition: Manual ignition is always possible even when the power is cut off or in the event of prolonged power failure. [. . . ]