User manual BESAFE IZI COMBI

[. . . ] REARWARD- & FORWARD-FACING USER MANUAL ECE R44 04 GROUP WEIGHT AGE 0+/1 0-18 kg 6m-4y 1 Thank you for choosing BeSafe iZi Combi. BeSafe has developed this seat with much care, to protect your child during the next phase of her or his life. Vital information · It is NOT ALLOWED to mount the seat in a front passenger seat WITH AN ACTIVATED AIRBAG. · iZi Combi can be installed rearward-facing with a 3-point car belt, approved to UN/ECE Regulation No. · iZi Combi can be installed forward-facing with a 3-point car belt, approved to UN/ECE Regulation No. · iZi Combi is approved in groups 0+ and 1, rearward-facing from 0-18 kg and group 1, forward-facing from 9-18 kg. [. . . ] 8- Turn the seat into the right position (with the front brace against the back rest). 9- To enlarge the space for the legs of the child, you can move the front brace outwards with the ratchet. 10- In the front seat of the vehicle, you should position the seat against the dashboard. 11- Push the floor support down to the floor. The floor support must go through the belt loop and the belt loop must be led into the hook on the floor support (15). 12- Position the 3 point car belt. Place the hip belt over the base of the seat behind the belt guiding horns on each side. Tension the shoulder belt. (16) 13- Pull out the shoulder belt and make it into a loop (17a). 14- Thread the loop through the metal part of the red belt block (17b). 15- Guide the loop into the red slit (17c). 16- Tighten the belt by pulling the top part down (17d). (17) (15) a b c d (18) Rearward-facing in the front seat ! 12 13 17- Move the front brace outwards with the ratchet. Continue tightening until the brace is pressed well into the back rest of the vehicle seat (19). Forward-facing belt installation It is NOT ALLOWED to mount the seat in a front passenger seat WITH AN ACTIVATED AIRBAG. 1- When mounting in the back seat of the vehicle, push the front seat of the vehicle forward as much as possible. 2- When mounting in the front seat of the vehicle, adjust the back rest in an upright position. 3- Remove the floor support and the front brace from the seat. 4- Put the child seat on the seat of the vehicle. 5- Release the release handle at the back of the head rest and push the head rest down while keeping the head rest upright (23). (23) (22) ! (19) 18- Connect the anchor belts with the child seat. 19- Tighten the anchor belts to their maximum (20). 20- Lock the floor support with the locking bolt (21). (20) (21) Removing the seat 1- If the seat is installed in the back seat of the vehicle, push the front seat of the vehicle forward as much as possible. 2- Move the front brace inwards with the ratchet, not further than the stop sign. 3- Remove the locking bolt from the floor support, adjust the floor support in the highest position and lock again with the locking bolt. 5- Remove the car belt from the front brace and the seat base. 6- Pull the seat back towards the front. [. . . ] · Make sure all passengers are informed about how to release your child in case of emergency. · An unoccupied child seat should always be fastened in the vehicle. · Make sure luggage or other objects are properly secured. Unsecured luggage may cause severe injuries to children and adults in case of accidents. [. . . ]