User manual BESAFE IZI COMBI ISOFIX

[. . . ] Make sure that the floor support is fully pushed down. When installing forward-facing the floor support and the front brace shall not be used. · When installed with ISOfix: Make sure the indicators are green before you drive. · We recommend to use the seat as long as possible in the rearward-facing installation. [. . . ] The indicators will show red when the ISOfix connectors are released (13). (13) 17- Positioned in the back seat of the vehicle, you should, if possible, push the front seat of the vehicle backwards, so that it is in contact with the child seat. If it is not possible to obtain contact with the child seat, push the back rest of the front seat of the vehicle forward so that the distance between child seat and back rest of the front seat of the vehicle is minimum 25 cm. Positioned in the front seat of the vehicle, you should position the seat against the dashboard. (12) 5- Push the switch on each side and push the ISOfix connectors into the base (14). (14) 6- Pull the seat back towards the front. Turn the seat so you can easily remove the seat. 7- Remove the insertion clips from the vehicle. Place them under the base of the child seat. 8 9 Forward-facing belt installation ! It is NOT ALLOWED to mount the seat in a front passenger seat WITH AN ACTIVATED AIRBAG. 1- When mounting in the back seat of the vehicle, push the front seat of the vehicle forward as much as possible. When mounting in the front seat of the vehicle, adjust the back rest in an upright position. 2- Remove the floor support and the front brace from the seat. 3- Put the child seat on the seat of the vehicle. 4- Release the release handle at the back of the head rest and push the head rest down while keeping the head rest upright (16). (16) (15) 7- Put the shoulder belt through the belt clamps. 8- Push the seat firmly into the car seat. 9- Tight installation is most important for forward facing seats. Tension the belts as follows: Pull the shoulder belt upwards (A). Have a firm grip on the shoulder belt in the seat area (B). Pull upper belt part on the door side and close clamp D (18). 10- Adjust the belt guiding hook outwards with the ratchet (19). Continue tightening until the seat is pressed well into the back rest of the car seat. Push the head rest in the correct position (refer to `Positioning of the child' on page 12). The seat is now ready to use. C B D (18) A (19) Removing the seat 1- Loosen the tension in the car belt by moving the belt guiding hook inwards with the ratchet, not further than the stop sign. 5- Pull the hip belt around the bottom base of the seat and click the car belt in the buckle (17). 6- Position the hip belt over the belt guiding hook (17). (17) 2- If the seat is installed in the back seat of the vehicle, push the front seat of the vehicle forward as much as possible. [. . . ] We recommend using a (BeSafe) protection cover in these places to avoid cuts, marks or discolouration on the interior of the vehicle, especially in vehicles with leather or wooden interior. 18 19 Guarantee · All BeSafe products are carefully designed, manufactured and tested. All of our BeSafe child seats are tested periodically out of our continuous production in our test laboratory. Furthermore they are tested by independent test institutes. · Should this product prove faulty within 24 months of purchase due to materials or manufacturing fault, except covers and harness straps, please return it to the original place of purchase. [. . . ]