User manual BH FITNESS H-283

[. . . ] Remove the screws from the base of the monitor, connect the terminals for the feedback cable (21) to those on the monitor (32), Fig. 3, then slide the front of the monitor down onto the plate on the main post (4), making sure not to snag any of the wires, fit the screws and tighten, plug the terminal for the handgrip (24) into the rear of the monitor, Fig. This function counts up or down in steps of one second, up to a maximum of 99:00 seconds. [. . . ] Press the MODE key to start the small CAL (CALORIE) window "E 3" will appear on the screen, make sure that both your hands are placed on the handlebar sensors (R), Fig. If no signal is received after a further 5 seconds then the screen will revert to the previously displayed function. On this model the pulse rate is measured by placing both hands on the sensors (R), located on the handlebar, as shown in Fig. When both hands are placed on the sensors the heart symbol on the righthand side of the screen, marked PULSE, will begin to flash and after a few seconds a heart rate reading will be displayed. If both hands are not placed correctly as shown in Fig. 6 then the pulse function will not work. If a "0" appears on the screen or the heart symbol does not flash then make sure that both hands are placed on the sensors and that the connectors (32) are connected at the back of the electronic unit. This electronic device is equipped with a recovery test function. This offers you the advantage of being able to measure how long it takes your heart rate to recover after having finished the exercise. After finishing the exercise leave your hands on the pulse sensors (R) and press the "RECOVERY Fitness Test" button and this will start a one minute countdown. Only the Time and Pulse rate function read-outs will remain displayed. When the minute is up, the electronic device will work out the difference and your fitness rating will be displayed up on the screen: "F1, F2, . , F5, F16; where F1 is the best (fitness "Excellent") and F6 the worst (fitness "Very Poor"). Pressing the RECOVERY button will take you back to the main screen, where the functions will be in the same mode as when the TEST began. The comparison between the worked heart rate and the recovery heart rate provides a fast, simple method of gauging how fit you are. Your fitness rating is a guideline that shows you how fast your heart recovers after physical exertion. [. . . ] - Make sure that the connection cable is connected. Problem: The display does not come on or the displayed segments are very weak Solution: a. - If they are run down change them immediately Problem: Display segments of a function read-out are not visible or error messages for a particular function appear. [. . . ]