User manual BH FITNESS H916 SB2 V1

[. . . ] DO NOT use accessories that are not recommended by the manufacturer. Do not place sharp objects near the unit. Do warm up stretching exercises before using the unit. Do not use the bicycle if it is not working correctly. [. . . ] ADJUST THE HANDLEBAR VERTICALLY Figure 5. Position the handlebar (B) at a comfortable distance for doing exercise but without going beyond the "MAX" marks, now tighten knob (Y) securely. 2. FIT THE PEDALS The assembly instructions for the pedals must be followed exactly, fitting these incorrectly could damage the screw thread on either the pedal or the crank. Right and left refer to the position that the user adopts when sitting on the saddle to do the exercises. The right pedal, marked with the letter (R), screws onto the right crank, also marked with an (R), in a clockwise direction. The left pedal, marked with the letter (L), screws onto the left crank, also marked with an (L), in an counterclockwise direction. Fit the monitor (m) into the bracket (n). Take the middle cable and connect terminal (h) to terminal (k), coming out of the bottom of the main body (A). Insert the jack on the middle cable into the back of the monitor (see the following instructions for the monitor). EXERTION SETTINGS Figure 7. To provide an even level of exertion during exercise, this appliance is equipped with a tensioning control (Z), located on the stem of the main body (A). This provides various exertion settings when turned. To increase/decrease pedal resistance turn the tensioning control (Z) until the exertion level best suits your exercise requirements. During exercise the flywheel will get hot due to the braking effect, so when you have finished exercising it is advisable to set the tensioning control (Z) to minimum in order to help stop the brake shoe from hardening. This tensioning control (Z) is equipped with an emergency braking system which, when applied with force (as shown by the arrow in Figure 7), produces a much sharper braking effect. 3. Fit the saddle bracket (F), onto the horizontal saddle tube (G). Fit the saddle into position and tighten the nuts onto the bracket securely. Next insert the horizontal saddle tube (G) through the hole on the saddle post (H). Position it correctly and tighten the knob (S). Insert the saddle post (H) into the boss on the main body (A), position it comfortable for doing exercise and tighten the saddle post by using the adjustment knob (T) turning it clockwise. Loosen the saddle post adjustment knob (T) slightly by turning it counterclockwise, move the saddle to a position comfortable for doing exercise H-916 SB2 Indoor Cycle 5 ASSEMBLY GUIDE LEVELLING Figure 7. Once the unit has been placed into its final position, make sure that it sits flat on the floor and that it is level. This can be achieved by screwing the adjustable feet (13) up or down. MOVEMENT & STORAGE Figure 7 and Figure 8. [. . . ] EXCLUSIVE REMEDY The exclusive remedy for any of the above warranties shall be repair or replacement of defective parts, or the supply of labor to cure any defect, provided that labor shall be limited as detailed above. All labor shall be supplied by the local retailer and the product must be located within the retailer's service area. Travel time that is further than the retailer's normal service area will not be included in the products labor warranty. EXCLUSIONS AND LIMITATIONS This warranty applies only to the original owner and is not transferable. [. . . ]