User manual BIAMP 301 & 601

[. . . ] For best performance, adjust Trim so the Peak Indicator flashes only on occasional peaks in signal level (see Pad on next page). Channel Level: These controls adjust the level of channel signal sent to the Main Out section. Level control settings will vary from channel to channel, depending upon the desired mix. However, for best performance, higher settings should center around the 12 o'clock position (unity gain). [. . . ] Stack Input signal is combined with the channel signals, before being sent to the Main Out section. Connect balanced inputs with high to (+), low to (-), and ground to ( ). For unbalanced use, connect inputs with high to (+) and ground to both (-) & ( ). Patch: These three terminals provide an insert point for connection of external processing equipment at the Main Out section. Patch is post-EQ (Bass & Treble) and pre-Master Level. The (out) terminal provides a send to the external device. The (in) terminal provides a return from the external device Ground for both connections is supplied by the ( ) terminal. Patch may also be used as an unbalanced, pre-Master Level output, with the (out) terminal as the send and the ( ) terminal as ground. Depress the Patch Enable switch only when Patch is used as an insert, and release the Patch Enable switch when Patch is used as an output (see Enable Switches below). Remote: These three terminals allow remote control of the Main Out level. Remote controls can be level pots and/or mute switches. Controls may be wired up to 2000 feet from the mixer, using 2-conductor shielded cable (see Remote Control on page 4). Potentiometers should be 5k~50k ohms (linear taper). Switches may be used alone (on/off) or with variable resistors (adjustable mute). An external ramp voltage may also be used. Depress the Remote Enable switch only when using remote controls (see Enable Switches below). Enable Switches: These switches activate the normal functions of the Patch & Remote terminals (see above). Patch terminals may still be used as an unbalanced output even when disabled. Remote terminals do nothing unless enabled. If Remote is enabled, but no control is connected, signal will be muted (off) at the Main Out. [. . . ] BIAMP SYSTEMS DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. The remedies set forth herein shall be the purchaser's sole and exclusive remedies with respect to any defective product. No agent, employee, distributor or dealer of Biamp Systems is authorized to modify this warranty or to make additional warranties on behalf of Biamp Systems. statements, representations or warranties made by any dealer do not constitute warranties by Biamp Systems. [. . . ]