User manual BIAMP 801I

[. . . ] If input signal exceeds the normal operating range of the Trim control, assign the rear panel Pad switch (see DIP switches on next page). Level (Channels 1~8 & Aux): These controls adjust the amount of signal sent from the individual input channels to the mixer output section. Optimum Level settings are near the 12 o'clock position (unity gain). Bass: This control provides low-frequency tonal adjustment (±10dB @ 100Hz) for signals at Main Patch & Main Output. [. . . ] Remote: This plug-in barrier strip provides connection for an optional remote master level control (model RP-L1) (see Remote Control on pg. An external potentiometer (5k~50k ohm linear taper) or external ramp voltage (0~+10VDC) can also be used. Potentiometers are wired high (V), wiper (C), and low ( ). Ramp voltage is wired positive (C), and ground ( ). The Remote port must be enabled before remote master level control is possible (see Master DIP switches below). Input & Direct Out (Channels 1~8 & Aux): These plug-in barrier strips provide the balanced mic/line Inputs to the mixer (Channels 1~8 only). For balanced connection, wire high (+), low (-), and ground ( ). For unbalanced connection, wire high (+) and ground to both ( ) & (-). Phantom power (+24VDC) is available for condenser microphones (see DIP Switches below). The Aux input accepts either balanced mono line input or unbalanced stereo line input (see DIP switches below). Aux input cannot accept mic input signal, and does not provide phantom power. Unbalanced 'prefader' Direct Outputs are available on Channels 1~8 & Aux, using the (d. Master DIP Switches: These switches assign functions to the mixer as a whole (when pushed up). Slave assigns the mixer as an expander to a `master' mixer. Tone Out bypasses the front panel tone controls (Bass & Treble). Override allows automatic muting of other inputs when signal is present in Channel 1. Remote allows remote control of Main Output level, by enabling the Remote terminals (see above). DIP Switches (Channels 1~8 & Aux): These switches assign functions to the individual inputs (when pushed up). Pad attenuates channel signal -18dB (-10dB at Aux) for line input. [. . . ] Biamp Systems shall not be responsible or liable for any statement, representation or warranty made by any dealer or other person. No action for breach of this warranty may be commenced more than one year after the expiration of this warranty. BIAMP SYSTEMS SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING LOST PROFITS OR LOSS OF USE ARISING OUT OF THE PURCHASE, SALE, OR USE OF THE PRODUCTS, EVEN IF BIAMP SYSTEMS WAS ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Biamp Systems 9300 S. W. Gemini Drive Beaverton, Oregon 97008 (503) 641-7287 585. 0204. 90B DoC MLM201003 EC Declaration of Conformity Biamp Systems Corporation, as manufacturer having sole responsibility, hereby declares that the following described product complies with the applicable provisions of the DIRECTIVES below except as noted herein. [. . . ]