User manual BIAMP AUDIAEXPI

[. . . ] AudiaEXPI & AudiaEXPO Input & Output Expanders Operation Manual Biamp Systems | 9300 S. W. Gemini Drive | Beaverton, OR | 97008 | USA | +1. 503. 641. 7287 | www. biamp. com AudiaEXPI & AudiaEXPO TABLE OF CONTENTS Bl ank AudiaEXPI - front & rear panels pg. 2 AudiaEXPO - front & rear panels pg. 16~18 July, 2009 AudiaEXPI & AudiaEXPO INTRODUCTION AudiaEXPI is an input expander for AUDIA®, the benchmark in digital audio systems for demanding professional sound installations. [. . . ] This is a networked system using two AudiaFLEX 20x4CM units and two AudiaEXPO 8-Output Expander units (forty inputs, twenty-four outputs, CobraNet). An example system diagram is shown on the next page. Each courtroom is shown as having ten microphones. AUDIA inputs accept microphone or line-level signals equally well, so some inputs could instead be from sources such as playback of recorded evidence. Inputs from the four courtrooms are connected to the two AudiaFLEX units, which are located in a local equipment closet. Each AudiaFLEX unit accommodates inputs from two of the courtrooms, and provides four system outputs. In this case, one unit provides the outputs necessary to feed a hearing assistance system in each of the courtrooms. The other unit is providing the outputs needed for sound reinforcement. These outputs are feeding an MCA8050 multi-channel amplifier. The MCA8050 amplifier has eight channels which have been bridged in pairs, essentially creating four channels of 100 watts each. With four TDT100 transformers installed internally, the MCA8050 is prepared to drive the 70 volt distibuted speaker system in each of the four courtrooms. Courtroom A Courtroom B distributed 70V speaker system distributed 70V speaker system microphones #1~10 microphones #1~10 Courtroom C Courtroom D distributed 70V speaker system distributed 70V speaker system microphones #1~10 microphones #1~10 CobraNet and Ethernet from both AudiaFLEX units 4-track 4-track 4-track 4-track hard-disk hard-disk hard-disk hard-disk are tied together through an Ethernet switch. This court recorder court recorder court recorder court recorder allows sharing of digital audio signals (CobraNet) and control data (Ethernet) on a network. Connected to the same Ethernet switch, and functioning as part of the same network, are two AudiaEXPO units. These two AudiaEXPO units are physically located in a central computer/recording office. The maximum distance between any AUDIA unit and an Ethernet switch is 300 feet. Therefore, this system can span up to 600 feet between the equipment closet and the computer/recording office. Additional Ethernet switches, or even fiber-optics, can further extend distances between units on the network. Each AudiaEXPO receives eight channels of digital audio via CobraNet, over a single CAT5 cable. These eight channels of digital audio are then converted to analog audio, and appear on eight separate output connections. Each AudiaEXPO provides the appropriate channels of audio for two of the four court recording systems. Mixing and processing of these signals (to achieve proper microphone/track assignment and consistent recording levels) has already be accomplished back at the AudiaFLEX units. Design example: Recording signals are not gated or equalized, but Levelers are employed to ensure consistent levels and intelligibility. [. . . ] (2kg) < 0. 006% < 0. 065% -123dBu Power Consumption (115/230VAC 50/60Hz): 60dB Dimensions: < 25 watts +0/-0. 4dB Maximum Input (mic/line): Phantom Power: Input Gain Range (variable trim): A/D Converters: +20dBu +48 VDC (10mA/input) 0dB ~ +60dB 24-bit (48kHz sampling) AudiaEXPO SPECIFICATIONS Frequency Response (20Hz~20kHz @ -20dBFS): THD+N (20Hz~20kHz @ -20dBFS): Dynamic Range: Crosstalk (channel-to-channel @ 1kHz): Output Impedance (balanced): Maximum Output (balanced): Output Gain Range (variable trim): +0/-0. 4dB < 0. 006% 110dB < -90dB 200 ohms +24dBu -70dB ~ 0dB D/A Converters: Power Consumption (115/230VAC 50/60Hz): Dimensions: height width depth Weight: 1. 75 inches (44. 5mm) 19 inches (483mm) 5. 75 inches (146mm) 4. 3 lbs. (2kg) 24-bit (48kHz sampling) < 25 watts 12 BLOCK DIAGRAMS AudiaEXPI BLOCK DIAGRAM LCD & encoder Analog Inputs Processor Logic Inputs Trim & Peak A/D CM-1 CobraNet digital audio AudiaEXPO BLOCK DIAGRAM LCD & encoder Analog Outputs Processor Logic Inputs Trim D/A CM-1 CobraNet digital audio 13 WARRANTY BIAMP SYSTEMS IS PLEASED TO EXTEND THE FOLLOWING 5-YEAR LIMITED WARRANTY TO THE ORIGINAL PURCHASER OF THE PROFESSIONAL SOUND EQUIPMENT DESCRIBED IN THIS MANUAL 1. BIAMP Systems warrants to the original purchaser of new products that the product will be free from defects in material and workmanship for a period of 5 YEARS from the date of purchase from an authorized BIAMP Systems dealer, subject to the terms and conditions set forth below. If you notify BIAMP during the warranty period that a BIAMP Systems product fails to comply with the warranty, BIAMP Systems will repair or replace, at BIAMP Systems' option, the nonconforming product. [. . . ]