User manual BIAMP D60EQ

[. . . ] Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. [. . . ] Connect to ~115/230 VAC 50/60 Hz AC power. Make sure that the line voltage selector switch and fuse have been correctly set before plugging in. Do not remove or defeat the AC ground prong on the plug, as this constitutes a shock hazard. Set this switch to "115" for nominal line voltages of 110-120 VAC. Set this switch to "230" for nominal line voltages of 220-240 VAC. Make sure that the appropriate fuse is installed when changing voltage selections. The unit is set for 115 volt operation when shipped from the factory. Replace fuse only with same type and value. For 115 volt operation, use a T 2A L 250V fuse. For 230 volt operation, use a T 1A L 250V fuse. 4. 2. 3. Output Barrier Strip. The output barrier strip provides connections for the output of the amplifier. The Common terminal is the output "ground" connection. When the unit is shipped from the factory, the distribution autoformer is not hooked up and signal is only present at the 4 ohm output. To use the 8, 70V, or 100V outputs, the jumper wire must be connected from the 4 output terminal to the autoformer input terminal. NOTE: From the factory, the D60EQ has an 18dB/octave 180Hz high-pass filter enabled. This high-pass filter must remain enabled whenever an autoformer output is being used (8, 70V, or 100V). The high-pass filter should be disabled only when using the `direct' 4 output (see Options & Accessories on page 8). CAUTION: High voltages may be present at the output terminals. [. . . ] BIAMP SYSTEMS DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. The remedies set forth herein shall be the purchaser's sole and exclusive remedies with respect to any defective product. No agent, employee, distributor or dealer of Biamp Systems is authorized to modify this warranty or to make additional warranties on behalf of Biamp Systems. [. . . ]