User manual BIAMP DPM-28

[. . . ] 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. A grounding type plug has two blades and a third grounding prong. The third prong is provided for your safety. [. . . ] 25V comin India xfmr Assembled mic/line FUSE 110-120/220-240V~ 50-60Hz 300W FUSE: T 8A/4A L 250V 120V/240V class 3 wiring 4 gnd class 2 wiring input input 6 input 5 input 4 input 3 input 2 tel input 1 AC Power Entrance: The switch applies power to the unit. The receptacle accepts the detachable Power Cord. The Power Cord is for connection to three-prong grounded outlets. CAUTION: Do not remove or defeat the ground prong on the Power Cord, as this constitutes a shock hazard. Equipment shall be connected to a mains socket outlet with a protective earthing connection. Plug is main disconnecting device and it shall remain readily operable. Fuse: Replace Fuse with same type and value only. NOTE: If the Fuse continues to blow, the amplifier may require service. Power Selector Switch: This switch selects either 120 Volt or 240 Volt AC operation. Output Connector: These screw terminals provide the speaker outputs from the amplifier. CAUTION: To reduce the risk of electric shock, do not perform any servicing unless you are qualified to do so. When using Line Out for external amps and/or Amp In for stacking, the Link switch may remain in the (on) position. Low Cut: This switch controls a low-cut filter (12dB/octave @ 125Hz) at the amplifier input. CAUTION: To avoid output fault conditions, Low Cut must be used when driving 25/70/100 Volt speaker systems (see Installation Instructions on pg. Also, any other system equalization affecting frequencies below 125Hz should remain flat or be used as cut-only. This also precludes boosting of the Bass control (see above) in these applications. DIP Switches: The five DIP switches above each input are used to assign specific functions to those individual channels. Phantom Pwr assigns +48 Volts DC phantom power to the channel input, for powering condenser microphones. CAUTION: To avoid damage to equipment, assign phantom power only on channels being used as inputs for conderser microphones. When signal is present in a priority channel, any nonpriority channels which are assigned to Auto Mute will be muted by their selected amounts (see below). NOTE: A priority channel cannot be auto muted by another priority channel, but a priority channel can be manually muted (see below). Auto Mute assigns a (non-priority) channel to be muted whenever signal is present in any priority channel. [. . . ] 4) Strip 0. 25" (6. 4mm) of insulation from each lead. 5) Slide one piece of the supplied heat shrink tubing on to each wire. 6) Crimp the ring lug terminals on to the prepared wires. 7) Slide the heat shrink as far onto the shank of the ring terminal as possible. [. . . ]