User manual BIAMP RED-1

[. . . ] · 330' (100m) Ethernet cable length can be extended with standard PoE network technology (routers, switches, hubs, media converters) · Connects with standard RJ45 or insulation displacement connector (IDC) · Covered by Biamp Systems' five-year warranty RED-1F RED-1 3 RED-1 FRONt pANEl Select Scroll Latch Setup and Use The Audia and Nexia software provides an intuitive interface for setup and programming of the RED-1. The information supplied by this manual relates to physical connections and device setup. For more details on software setup, please consult the Audia or Nexia Help File. [. . . ] Device IDs may also be assigned via Device Maintenance in the Audia or Nexia software. Edit Network Configuration To edit the network configuration, scroll to the Network icon and press the Select button. The default setting (Static) initializes the IP address to 192. 168. 1. 201, network mask to 255. 255. 255. 0, and gateway to 0. 0. 0. 0. These default settings allow RED-1 to be discovered by an Audia or Nexia device that also has default settings. Network settings may also be assigned via Device Maintenance in the Audia or Nexia software. Edit Lock Code To set password protection, scroll to the Key icon and press the Select button. Use the scroll wheel and Select button to choose the desired characters. During normal operation, holding down the Select button for two seconds will lock the unit, and the user will be prompted for the Lock Code before obtaining access. Lock Codes may also be assigned via Device Maintenance in the Audia or Nexia software. 7 RED-1 sEt Up Edit Display Brightness To change the brightness of the OLED panel, scroll to the Display Brightness icon and press the Select button. Use the scroll wheel and Select button to make adjustments. The first setting represents the normal operational display brightness, and the second setting represents the dim display brightness. Display brightness cannot be assigned via Device Maintenance in the Audia or Nexia software. Edit Timeouts To change the lock, dim, and sleep timeouts, scroll to the Timeout icon and press the Select button. Use the scroll wheel and Select button to make changes. For lock and dim, the timeout can be none or range from 5 seconds to 30 minutes; for sleep, the timeout cannot be none. Timeouts may also be assigned via Device Maintenance in the Audia or Nexia software. View Device Information To view information about the unit, scroll to the Information icon and press the Select button. The Serial Number, MAC Address, Firmware Version, and System ID are displayed. The Serial Number is helpful in identifying physical units/ locations when naming them via Device Maintenance in the Audia or Nexia software. The color code uses the T568A standard for wiring. When using the T568B wiring scheme, please note that the orange wire pair (OR and WH/OR) and green wire pair (GR and WH/GR) need to be swapped. After inserting the wires, press the tabs until the insulation is punctured with an audible click. [. . . ] Any alterations to the product not agreed upon and directed by Biamp Systems Corporation will invalidate this declaration. Product Models: Product Description: Applicable EC Directives: LVD Directive (2006/95/EC) EMC Directive (2004/108/EC) RED-1, RED-1F Control Accessories for use with audio DSPs. Applicable Harmonized Standards: Safety Emissions Immunity EN 60065:2002 EN 55103-1:1996, Environment E2 EN 55103-2:1996 Special Considerations for Product Environment or Compliance: Shielded cabling must be used for system connections. [. . . ]