User manual BIAMP VOCIA OUTPUT

[. . . ] Power Indicator LED On the left of the front panel, the VO-4 has a single LED that indicates power and connectivity status: 1. Not illuminated: The device is not powered. 2. Flashing green: The unit is receiving power but not data, or the unit has not been configured correctly. [. . . ] Device iD switches should be set using a 0. 1 inch (2. 5mm) to 0. 12 inch (3. 0mm) flat blade screwdriver. more information on setting iDs and the hexadecimal numbering scheme used in Vocia can be found in the Vocia Help File. Please note: Changes made to the Device iD while connected to the network require a power cycle in order to take effect. All CobraNet routing and bundle assignments are processed by the Vocia devices locally. Vocia makes dynamic use of available bundles in CobraNet. Vocia devices are currently not interoperable with non-Vocia devices. 5 VO-4 rear panel cOntrOls This connection carries control data, power, and digital audio over CobraNet. The maximum distance between any unit and an Ethernet switch is 328 feet (100 meters) when using copper cabling. Additional Ethernet switches and/or fiber-optic cable can be used to further extend distances between units on a network. Please note that CobraNet limits network extensions to seven hops (one-way transmissions) within a network. If other network traffic shares an Ethernet switch with the Vocia network, a managed switch should be used with separate VLANs. All Ethernet wiring is to be done using shielded CAT5, CAT5e, CAT6, or CAT7 cable. VO-4 BIAMP SYSTEMS Designed in Australia Assembled in USA N24138 Model VO-4 YEL:in use/conductor GRN:link/act Device ID GND Control Outputs Control Inputs Audio Outputs CobraNet® PoE IEEE 802. 3af Class 0 MSB LSB C NC NO C NC NO 1 2 C NC NO 3 C NC NO 4 1 2 3 4 10V (100mA) +1 +2 +3 +4 Ethernet switch with PoE VO-4 BIAMP SYSTEMS Designed in Australia Assembled in USA N24138 Model VO-4 YEL:in use/conductor GRN:link/act Device ID GND Control Outputs Control Inputs Audio Outputs CobraNet® PoE IEEE 802. 3af Class 0 MSB LSB C NC NO C NC NO 1 2 C NC NO 3 C NC NO 4 1 2 3 4 10V (100mA) +1 +2 +3 +4 Ethernet switch without PoE PoE injector AC Power 6 VO-4 rear panel cOntrOls Control Outputs The Control Outputs, labeled 1 through 4, are isolated, voltage-free, software-configurable relay outputs. The individual pins are labeled as follows: 1. (NC): normally closed (connected to C when relay is not energized) 3. (NO): normally open (connected to C when relay is energized) Control Inputs The Control inputs are labeled as follows: 1. (10V): 10V reference voltage (when used as a switch input, a switch must be connected between the input and logic common terminal) Audio Inputs Four plug-in barrier strip connectors provide analog audio signal output. [. . . ] BiAmP Systems disclaims all other warranties, expressed or implied, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. The remedies set forth herein shall be the purchaser's sole and exclusive remedies with respect to any defective product. [. . . ]