User manual BIFINETT KH 1101 1.5 L KETTLE

[. . . ] If the base should unintentionally get moist, let it dry out completely. Please ensure that the power cable never gets wet or moist in use. Never allow it to get pinched or otherwise damaged. [. . . ] ­ the kettle, plug and power cable are in good working order. and all packaging material has been removed from the kettle. Fill the kettle with water to the MAX mark and let it come to a boil once as described in the next number. A lamp in the window of the level indicator indicates that the kettle is now heating up. The kettle switches itself off when the water is boiling properly. The ON switch pops out again and the lamp goes out. In order to interrupt heating, push the ON switch up again (the lamp also goes out in this case). Please pull the plug out of the socket before you lift the pot from the base. This prevents water from spilling onto the electrical connections in the base and causing a short-circuit. For safety reasons and to avoid injuries do not open the lid when the water is boiling or very hot. Open the cover by pressing the release button. Hold the pot vertically when filling it to ensure that the level indicator on the side properly indicates the water level. ­ at least to the MIN mark to ensure that the kettle does not overheat, ­ no more than to the MAX mark to ensure that boiling water does not spill over. And place the pot on the base until it is set on its base completely straight. And press the ON switch downward until it locks into place. No operating elements are located inside the device. [. . . ] After cleaning, you can insert the screen again and press down firmly ­ and it's ready!Let the kettle cool off completely before you put it away. Wind the power cable around the holder under the bottom of the kettle. [. . . ]