User manual BIFINETT KH 1133 PLASTIC WATER HEATER WITH THERMOSTAT

[. . . ] Make certain that the base with the electrical connections never comes into contact with water!Let the base dry completely before using, should it ever accidentally become wet. Make certain that the power cord never becomes wet or damp during operation. [. . . ] Before starting up the device, make certain that . ­ ­ the device, power plug and power cord are in perfect condition and . Now insert the power plug into the power socket . And press down the switch until it snaps into the depressed position. A red light indicates that the device is now heating up. the device switches itself off once the water is at a full boil. The switch then snaps back out and the red light goes out. to interrupt the heating , slide the switch back to the up position. This also causes the red light to go out. Warning: Pull the power plug out of the power socket before removing the kettle from the base. This prevents any water spilling out from falling on the electrical connections in the base, which could cause a short-circuit. Fill the device with water up to the MAX mark and let the water come to a full boil as described in the next section. You should only heat as much water as you need directly. This saves energy, water and time: · Remove the kettle from the base before filling it!Only then will the level indicator on the side correctly indicate the amount of water. To at least the MIN mark so that the device does not overheat, no higher than the MAX mark so that no boiling water spills out. [. . . ] Purchase a decalcifying agent suitable for use with food containers from a household goods stores (e. You can use a suitable product from a specialised dealer for the stainless steel container bottom. Wind the power cord around the holder on the bottom of the device. [. . . ]