User manual BIFINETT KH 400 EGG BOILER

[. . . ] To avoid accidents, never operate several household appliances from the same socket at the same time. . This egg boiler is intended only for domestic use. Do not leave the egg boiler to operate unattended or allow children to use it. [. . . ] Do not immerse the egg boiler in water or use liquids to clean it. Please refer to the section on "Cleaning and care". Keep this safety advice for later reference and if necessary pass it on to third parties. Should the mains cable become damaged, it must be replaced by the manufacturer, his service centre or electrical equipment repair centre. To prevent dangerous circumstances from arising, all repairs of electrical equipment must be carried out by suitably qualified electricians Technical information Model type: Operating voltage: Nominal load: Nominal frequency: KH-400 230 V AC 400 W 50 Hz Before using for the first time Wipe the water dish, egg holder tray and lid with a moist cloth. Electricity supply mains The mains supply voltage must correspond with that shown on the rating plate. List of parts Lid Egg holder Switch with integral indicator light Mains cable Measuring jug Egg piercer Non-stick water dish Cable tidy 4 Operation 1. Place the required amount of water into the water dish using the measuring jug. The quantity of water is adjusted according to the desired degree of hardness and the number of eggs to be cooked. Note: The information given here is based on medium-sized eggs (Size M). Use more or less water if you are boiling other sizes of eggs so that you achieve the desired degree of hardness. The following basic guidelines apply: if the eggs are too soft, you should use more water in the water dish than recommended. Take an egg in one hand and hold the measuring jug in the other. Make a slight prick in the top or bottom of the egg using the egg piercer on the bottom of the measuring jug. Place the egg with the prick facing downwards into one of the openings of the egg holder . Place the tray into the egg boiler and cover with the lid . Plug the egg boiler into the mains and press switch . The indicator light comes on to show that the egg boiling process has started. [. . . ] The plastic housing can be cleaned with a moist cloth but it must never be immersed in water. Finish off by gently rubbing the housing with a dry cloth. After use, the egg boiler should be kept in a dry cool place. [. . . ]