User manual BIKE FRIDAY TRAVELTRAILER

[. . . ] Our toll-free number in the US and Canada is 800-777-0258, international is +1-541-687-0487. You can also email service questions to service@bikefriday. com. Because we understand the needs of world travelers, we offer 24-hour technical support in emergencies. If necessary, please call our regular number and our answering service can forward you a Service Technician on call. 2. [. . . ] Each aachment point should be a sandwich consisting of trailer frame, flat Fig. washer, nylon TravelCase, flat washer and then thumb nut. 5. Add Thumb Nuts Place one of the flat washers over each threaded stud, and then loosely thread on the thumb nuts--do not tighten them yet. 8. Wheel Axles From one axle end remove the clevis pin, the flat washer and the rubber O-ring. Note the order of these parts when installing the trailer wheel. Fig. 5 Attach washers & thumb nuts. Fig. Attach Trailer Tongue Take the long trailer tongue and remove the thumb nut and one washer from the threaded stud. Slip the hollow end of the tongue over the end the of the T-bar so that the threaded stud in the tongue fits into the remainFig. Install Trailer Wheel Each trailer wheel has two bearings; one is flush with the outside of the wheel, and the other is recessed. Slide the trailer wheel over the axle end with the recessed side down and the flush side up (outside of the trailer). Fig. 9 Mount trailer wheel. 4 www. bikefriday. com 800-777-0258 · +1-541-687-0487 800-777-0258 · +1-541-687-0487 www. bikefriday. com 5 Accessories: TravelTrailer 10. Add Axle End Washers First install the rubber Oring so that it sits next to the wheel bearing; then install the flat washer over the Oring. Accessories: TravelTrailer 13. Stacker Strap (Tandem) The supplied nylon strap holds the upper TravelCase in place. Slip the small loop over the trailer tongue and run the strap through the TravelCase pull handle. Fig. 10 First O-ring, then flat washer. Fig. Insert Clevis Pin Insert the clevis pin through the hole in the axle end to secure the wheel. The flat washer should be lightly pressing against the clevis pin from the inside, with the O-ring acting as a sort of spring to keep the wheel Fig. Connect Trailer Hitch To aach the trailer hitch to your frame, simply pull the knurled collar on the coupler back while you push the coupler over the nipple on the frame. Fig. Mount Other TravelCase (Tandem) Lean the stacker unit back and remove the two thumb nuts and washers. Place the other TravelCase on the stacker so that the two threaded studs go into the axle holes in the case. the washers and thumb nuts and tighten securely. The photo also shows how you would access the lower case when touring. [. . . ] Claims must be made through Green Gear Cycling or an authorized dealer. This warranty covers bicycles and components purchased outside of the United States only if purchased through an authorized Green Gear Cycling dealer. This warranty does not cover normal wear and tear, improper assembly or maintenance, folding or unfolding, or installation of parts or accessories not originally intended or compatible with the bicycle as sold. Under no circumstance(s) shall Green Gear Cycling be responsible for incidental or consequential damages. [. . . ]