User manual BINATONE AC2000

[. . . ] OR Press TIMER button while the dialled digits are still displayed to restart the time. The LCD screen shows `00:00 00:00' 00:00 To stop, press TIMER button again. To continue the timer, press TIMER button again. Lift the Handset, listen for a dial tone. [. . . ] you have followed the steps listed in Section 2 to install and set up your AC2000 phone. all connectors are firmly inserted in their sockets. Everyday use ALWAYS check first that: Speed dialing using the One Touch memory location; 1 2 Lift the Handset. Press the One Touch memory location M1 button. The number dials automatically. Network connection This equipment is intended to be used in the UK only. Operation on other countries' PSTN termination points cannot be guaranteed. Declaration of conformity The AC2000 phone complies with the essential protective requirements and objectives of: EC R&TTE Directive 1999/5/EC EC Low Voltage Directive 2006/95/EC EC EMC Directive 89/336/EEC and conforms to the following relevant harmonized standards: Network: TBR37, TBR38 EMC: EN 55022, EN 55024 Safety: EN 60950 Waste electrical products must not be disposed of with household waste. This equipment should be taken to your local recycling centre for safe treatment. "I cannot make or answer calls. " Make sure you're using the telephone line cable that was supplied with your AC2000 phone. Other telephone line cables might not work. Troubleshooting continue. . . "The phone does not ring" Make sure you're using the telephone line cable that was supplied with your AC2000 phone. Other telephone line cables might not work. Check that the total REN value of all equipment connected to your telephone line is not more than 4. "The phone does not dial" Make sure you're using the telephone line cable that was supplied with your AC2000 phone. Other telephone line cables might not work. Disconnect all other instruments connected to the same line as the AC2000 phone and see whether you can make a call. Disconnect the Base unit from the telephone line and plug a different phone into the master telephone socket. If the call does not work, and you are using a two- way socket adapter, remove it and plug a telephone directly into the socket. If the call now works, the adapter may be faulty. If you cannot make a call, the fault may be on the exchange line. Contact the service provider (the BT engineers on 151, or your cable company). If you still cannot identify the cause of the problem, contact the Help Line on 0845 345 9677 Calls are charged at Local Call rate. Speed dialing using the Two Touch memory locations; 1 2 3 Lift the Handset. The display shows 'LoAd-' Press 0~9 for the memory location. The number dials automatically. T elephone operation continue. . . Memory Check 1 2 3 To check the number stored in a memory location. [. . . ] If the Base unit ever falls into water, DON'T retrieve it until you have unplugged the power lead from the mains and the telephone line plug from the telephone socket; then pull it out by the unplugged cables. NEVER use your classic wooden phone outdoors during a thunderstorm - unplug the Base unit from the telephone line when there are storms in your area. Damage caused by lightning is not covered by the guarantee. Cleaning and care Don't clean any part of your telephone with benzene, thinner or other solvent chemicals - this may cause permanent damage which is not covered by the Guarantee. [. . . ]