User manual BINATONE E800

[. . . ] Color profile: Generic CMYK printer profile Composite Default screen 11 Customising your handset Key tone Normally, whenever you press a button on the handset, you hear a `beep' tone. You can turn these tones off if you prefer. Contents of this User Guide 1 2 3 Where to find it Before you start Installation Switching on and off Making and answering calls Last Number Redial Caller Display Memory dialling Intercom, transfer and conference Handset registration Customising your handset Customising your base unit Indirect Network Cleaning and care Connection and conditions for use Technical details Guarantee and service Troubleshooting General points You can customise the settings of your e800 handset and base unit, using a menu which is shown on the handset's display. Please note that: If you don't press any button for about 25 seconds, the handset will time out and the display will return to standby mode. When you confirm any setting you have made, you'll hear a confirmation tone. [. . . ] You may be going out of range of the base unit. Move closer, or your call may be cut off. Check the Battery Level symbol on the display. You need to subscribe to the Caller Display feature from BT or your service provider. The caller may have withheld their number by dialling 141. Or they may be calling from a network that does not transmit the Caller ID (for example, it may be an international call). "I try to recharge the batteries, but I still get a warning that they are low. " You need to replace the batteries. To find out how to obtain replacements, call the Binatone Spares Department on 0845 345 9677, between 9. 00 am and 5. 00 pm, Monday to Friday. Dispose of used batteries safely -- never burn them, or put them where they could get punctured. DON'T use non-rechargeable batteries in your e800 -- they may burst, causing damage. to confirm Indirect Network "The Caller Display feature isn't working. " "The Indirect Network feature isn't working. " You must subscribe to an alternative network provider before you can use this feature. If you have more than one registered handset, you need to turn the feature on for each one individually, as well as setting the network access code on the base unit. Disconnect all other instruments connected to the same line as the e800 and see whether you can make a call. Disconnect the base unit from the telephone line and plug a different phone into the master telephone socket. If the call does not work, and you are using a two-way socket adapter, remove it and plug a telephone directly into the socket. If the call now works, the adapter may be faulty. If you cannot make a call, the fault may be on the exchange line. Contact the service provider (the BT engineers on 151, or your cable company). If you still cannot identify the cause of the problem, contact the Binatone Help Line on 0845 345 9677. E:\Binatone2005\e800_A2\e800_A2_01. vp 10 May 2005 15:47:09 Color profile: Generic CMYK printer profile Composite Default screen 1 Where to find it UP and DOWN buttons Press during a call to adjust the volume in the earpiece. Press to move through the list of stored numbers or Caller Display records. PHONE /OK button Press to begin or answer a telephone call. Press while programming to confirm your selection. Press during a call to make a note of a number in the Notebook. (Last Number Redial)/ CDS/ PAUSE button Press ONCE to make a repeat call to one of the last five numbers you dialled. [. . . ] To check whether a handset is registered, make sure mains power to the base unit is switched on and the handset is within range. The handset's display should show its number, and the `signal level' symbol on the display should show three bars. If the display shows Out of range continuously, you need to re-register the handset. To register a new handset or to re-register a handset 1 Press PROG button then 1 7 2 Use or to select a base unit Base units are numbered 1 to 4. [. . . ]