User manual BINATONE LATITUDE 650

[. . . ] LATITUDE 650 Private Mobile Radio ((PMR( 2. Installation 2. 1 Removing the Belt Clip a. Pull the Belt Clip Latch away from the PMR. While pulling the Belt Clip Latch, push the Belt Clip up as shown in Figure 1. [. . . ] Press the LOCK button to cancel DW mode and return to the normal mode. In the Dual Watch mode, the LCD screen will alternately display the Main and the DW channel numbers. 4. 4 Setting the VOX (Voice Activated) Sensitivity In VOX mode, the PMR will transmit a signal only when it is activated by your voice or other sounds around you. The unit will transmit for a further for 1 second even if you stop talking. To set the VOX mode and sensitivity level; a. Press the MENU button 3 times, until the (Vox) icon blinks on the LCD Screen. Press the (UP) or (DOWN) button to select ON/OFF . LE displays on the LCD Screen, with the numbers to right flashing. Press the VOX (1, 2, 3, 4 or 5) sensitivity. (5 is most sensitive, 1 is least sensitive). Press the LOCK button to confirm your selection and return to the normal mode. Note: When your PMR is first turned ON , the VOX function will be disabled. Note: When the Dual Watch function is activated, the VOX function will be temporarily disabled until the Dual Watch mode is turned OFF. DW Displays when the Dual Watch function is turned ON. Displays when the Key Lock feature is activated. Displays when the Stopwatch feature is turned ON. LE Displays when setting the speaker volume. Displays when Roger tone is turned ON. Flashes when in power save mode. Figure 6 Figure 7 Important: Turn OFF the PMR unit during intial charging. prior to initial use. Important: Check the channel activity by pressing and holding the M (Monitor) button. You will hear static if the channel is unoccupied. Do not transmit if someone is talking on the current channel. In order for other people to receive your transmission, they must also be on the same Channel and CTCSS code (if applicable) that you are currently using. Refer to the "Changing Channel" section for more information. 4. Functions and Settings 4. 1 Changing Channels The PMR has 8 available channels. To change channels, in normal mode; (DOWN) button to select the a. The channel changes from 1 to 8, or from 8 to 1. 4. 5 Setting the Channel Scan Channel scan performs searches for active signals in an endless loop from channels 1 to 8. Press the MENU button 5 times, until the SC (SCAN) icon, and Channel number, flash on the LCD Screen. 4. 7 Changing the Call-Ring tone You can use the Call-Ring tones to alert the other user/s or to identify yourself. [. . . ] 5 This equipment is intended for use in: Austria Finland Latvia Spain Belgium France Germany Greece Hungary Iceland Ireland Italy Liechtenstein Luxemburg The Netherlands Norway Poland Portugal Slovenia Sweden Switzerland Turkey UK Romania Slovakia Note: The PMR's Transmit and Receive function will still operate even if the Stop-watch function is in operation. However, the Call-Ring tone function will be temporarily disabled. 7. Specifications Channels Available CTCSS Sub-channel Output Power (TX) Range 8 Channels 38 for each Channel 0. 5W About 10 Kms. (Low) WARNING For Vehicles with an Air Bag Do not place your PMR in the area over an air bag or in the air bag deployment area. [. . . ]