User manual BINATONE LYRIS 310

[. . . ] Mute button 11. R(Recall) button 12. Pause button Set Time/Date 1 Insert the rigid clips of the stand into the slots on the bottom of the phone (near the rear of the base). Press down firmly until the flexible clips clicks into place. To remove the stand, (1) pinch the flexible clips, ( 2) pull back the stand, and then (3) slide up and forward (3) as shown below. You will need to set the correct time and date so they can be displayed correctly on the display. If you subscribe to a Caller Display service, the time and date will be set automatically on receipt of your first incoming call. [. . . ] Plug the telephone line cord free end into a modular wall jack. Press the cable into the groove so that the Base unit stands level. Lift the Handset and check for Dial tone in the earpiece. and 08453459677 0818762092 03 to Modular Wall jack inatoneonline. com/ Mark two points on the wall that are 92 mm apart to lay the fixing centers as shown below. 5 Set Flash Time 1 2 3 4 5 This telephone gives you the possibility to use the special services services of your network provider. When pressing the RECALL button, the phone generates a line interruption and the length depends on your Flash Time setting. The display shows ' SET 1 DATE '. Press UP or DOWN button until the display shows 'SET 3 FLASH'. Press UP or DOWN button to select 100 (default), 300, 600, or 1000. Press SET/STO button to confirm the setting. The display shows ' SET 1 DATE ' , you can continue with programming, or press DELETE button to return to standby mode. Lift the Handset, listen for a dial tone. Dial the telephone number you wish to call. The display shows the number as you dial(maximum of 14 digits will be shown). To end the call, return the Handset to the Base unit. When the phone rings; Lift the handset or press the SPEAKERPHONE button on the Base unit. The Call timer starts about 7 seconds after going on line. Dial out Stored number 2 3 Lift up Handset or press the SPEAKERPHONE button, press M1, M2, M3 buttons. The number dials automatically. Storing a Number in (0-9) two-touch memories 1 2 3 In standby mode, Key in the telephone number you wish to stored. Press SET/STO button. Press the (0-9) button to store the number in the selected memories. After the Guarantee has expired If the unit is no longer under Guarantee, first follow steps 1 and 2 as for repair under Guarantee. Call our Service Department on 0845 345 9677 and ask for a quotation of the repair charge and details of where to send your Lyris 310 for repair. Make sure you include with your Lyris 310: your name and address. a cheque or postal order for the value of the repair charge. Return your Lyris 310 to the address given by the Service Department. 8. Technical details Standard Lyris 310 Telephone Temperature range Operating 0 ºC to 40 ºC Storage -20 ºC to 60 ºC PBX compatibility Timed break recall: 98 ms. Signalling type: DTMF (dual-tone multifrequency) also called tone dialing. [. . . ] Remember to include the mains adapter 3. Return the unit to the shop where you bought it, making sure you take your sales receipt. Contents of this User Guide 1. Installation The Binatone Help Line is 3 . Wall mount installation available from 9. 00 am to 4 . [. . . ]