User manual BINATONE SPIRIT 410

[. . . ] Mute button 11. R(Recall) button 12. Pause button Set Time/Date 1 Insert the rigid clips of the stand into the slots on the bottom of the phone (near the rear of the base). Press down firmly until the flexible clips clicks into place. To remove the stand, (1) pinch the flexible clips, ( 2) pull back the stand, and then (3) slide up and forward (3) as shown below. You will need to set the correct time and date so they can be displayed correctly on the display. If you subscribe to a Caller Display service, the time and date will be set automatically on receipt of your first incoming call. [. . . ] Other telephone line cords may not work. Make sure the plugs click into place. Desk/Wall mounting continue. . . Insert the rigid clips of the stand into the slots on the bottom of the phone ( near the front of the base). Press down firmly until the flexible clips clicks into place. To remove the stand, (1) pinch the flexible clips, (2) pull back the stand, and then (3) slide up and forward as shown below. Press SET/STO button to confirm the setting. The display shows ' SET 2 LCD ' , you can continue with programming, or press DELETE button to return to standby mode. The display shows ' SET 1 DATE '. Press UP or DOWN button until the display shows 'SET 2 LCD'. Press UP or DOWN button to select your comfortable display viewing level (1~8). Press SET/STO button to confirm the setting. The display shows ' SET 2 LCD ' , you can continue with programming, or press DELETE button to return to standby mode. Set LCD Contrast 1 2 3 4 4. Plug the telephone line cord free end into a modular wall jack. Press the cable into the groove so that the Base unit stands level. Lift the Handset and check for Dial tone in the earpiece. and 08453459677 0818762092 03 to Modular Wall jack inatoneonline. com/ Mark two points on the wall that are 92mm apart to lay the fixing centers as shown below. 5 Set Flash Time 1 2 3 4 This telephone gives you the possibility to use the special services services of your network provider. When pressing the RECALL button, the phone generates a line interruption and the length depends on your Flash Time setting. The display shows ' SET 1 DATE '. Storing a Number in M1, M2, M3 memorys 1 In standby mode, Key in the telephone number you wish to stored. Guarantee and service This product is guaranteed against manufacturing defects for a period of 1 Year. This does not cover the product where the fault is due to misuse, abuse, use in contravention of the instructions, or where the product has been the subject of unauthorised modifications or alterations, or has been the subject of commercial use. In the event of a problem with the product within the guarantee period please return it to your nearest Argos store. If the item is shown to have had an inherent defect present at the time of sale, the store will provide you with a replacement. Your statutory rights remain unaffected. 2 Press UP or DOWN button until the display shows 'SET 3 FLASH'. Press SET/STO to confirm. Press UP or DOWN button to select 100 (default), 300, 600, or 1000. 3 3 Press M1. M2, M3 button to stored. 5 Dial out Stored number Storing a Number in (0-9) two-touch memorys 1 2 2 3 Press SET/STO button to confirm the setting. The display shows ' SET 1 DATE ' , you can continue with programming, or press DELETE button to return to standby mode. Lift up Handset or press the SPEAKERPHONE button, press M1, M2, M3 buttons. Telephone Operations Making a call 1 2 3 Lift the Handset, listen for a dial tone. [. . . ] The phone automatically dials the last number you called (maximum of 32 digits). To switch between the Handset and the Speakerphone Binatone operates a policy of continuous product improvement, and so reserves the right to make changes to the product and functions without notice. Binatone Help Line - 0845 345 9677 Calls are charged at Local Call rate. Connection and conditions for use You can connect your Spirit 410e phone to a direct exchange line (DEL) - a line connected to a local exchange, with its own phone number; to an extension socket connected to a DEL; or to an extension on an approved compatible PBX. Do not connect the Spirit 410 phone as an extension to a pay phone. The ringer equivalence numbers (RENs) of all instruments (phones, fax machines, etc. ) connected to an exchange line must not add up to more than 4 - otherwise, one or more of them may not ring and/or answer calls correctly. The Spirit 410 phone has a REN of 1, and most other telephones have a REN of 1 unless marked otherwise. Telphone Operation continue. . . Last Number Redial 1 2 Caller Display list Spirit 410 dynamically stores up to 30 groups (12digits) incoming information. [. . . ]