User manual BIONAIRE BASF1016GRC

[. . . ] Please proceed as follows: The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. DO NOT CONNECT either of these wires to the earth terminal in the plug. The earth terminal plug is marked with the letter "E", or with the earth symbol , or coloured GREEN, or GREEN and YELLOW. NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. [. . . ] · If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid hazard. 1 · A B C D E F G J K L H MISSING A PART FOR YOUR FAN?Please call 0800 052 3615 for assistance. DESCRIPTIONS See Figure 1 A. Base This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. 5. Center the front grill, aligning the Bionaire® logo so it is horizontal and parallel to the floor. Put onto the rear grill and snap in place. Make sure to secure the locking-clip on the bottom of the rear grill. (Figure 3) You should hear a click. Final Assembly 1. Insert the fan head assembly into the pole/ base assembly. The placement is done by a secure press fit that tightens the assembly in place so the fan head should be slightly pressed down. Lower the remote control holder on the right side of the front control housing and place the hollow end of the remote control housing (female end) onto the remote control holder. (Figure 4) REMOTE CONTROL HANDHELD UNIT · The remote includes control buttons for Power on/off " ", and Speed Selections "1 2 3", and Breeze/Sleep Modes " ". · The speed recall memories will also work with the remote control. · Your remote control requires 2 AAA batteries (not included) for operation. · Install the 2 AAA batteries in the rear compartment of the remote, according to the diagram shown inside. · Do not mix old and new batteries. · Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. ADJUSTMENT Height Adjustment This fan is equipped with an expandable pole, which allows you to adjust the height of the fan according to your preference. BASE POLE ASSEMBLY 1. Extend the upper pole through the top of the lower pole and secure it firmly by turning the height adjust knob clockwise. Insert the bottom of the lower pole into the hole on the top of the base. Figure 2 Figure 3 Figure 4 FAN HEAD ASSEMBLY You are now ready to assemble the fan head. 1: Position the rear grill over the motor shaft, making certain the 3 notches at the top and bottom of the rear grill fit over the 3 protruding notches on the motor housing. [. . . ] Carefully remove the front grill from the clips. Clean the fan blades, front and rear grills with a soft moist cloth. Replace the fan blades, tighten screw and securely fasten the front grill. Fan head, base and pole cleaning Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan base, pole and head. [. . . ]