User manual BIONAIRE BCH160

[. . . ] Turn Thermostat Control clockwise until the heater restarts. To make this occur less frequently adjust the Thermostat Control clockwise to the highest setting. Turn Mode Control to the 1 (Low Heat) or 2 (High Heat) setting. If the noise persists please call local Bionaire service reprensentative. · Not Enough Heat. Heater is in Low Heat or 1 setting. [. . . ] Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. DO NOT position where it can be touched by children, especially the very young. B C BCH160 Fig. 2 11. Allow a safe area around the heater away from furniture or other objects; at least 50 cm from the top and sides and 200 cm at the front. Do not use this heater when it is lying on its side. DO NOT use the heater in rooms with explosive gas (e. g. petrol) or while using inflammable glue or solvent (e. g. when gluing or varnishing parquet floors, PVC etc). DO NOT insert any objects into the heater. Keep the mains cord at a safe distance from the main body of the heater. If overheating should occur, the built-in overheating safety device will switch off the heater. The heater cannot be used adjacent to curtains or combustible material. Curtains or combustible material may be burned if the heater was installed incorrectly. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Discontinue use if the outlet or plug become hot to the touch. Overheating may indicate a worn or damaged outlet. Consult a qualified electrician for outlet replacement. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. OPERATING INSTRUCTIONS 1. Make sure the unit is in the OFF (O) position before plugging the heater into the wall socket/outlet. Once plugged in, the power light ring (D) will remain lit during operation. Avoid overloading your circuit by not using other high wattage appliances in the same outlet. At 1800 Watts, this unit draws 8. 2 Amps. [. . . ] and Ireland only F E NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. If a 13A 3-pin plug is fitted, it must be an ASTA approved plug, conforming to BS1363 standard. Replacement 13A fuses must be BSI or ASTA BS1362 approved. This product is fitted with a 13A plug complying to BS1363. [. . . ]