User manual BIONAIRE BCH4821

[. . . ] If the fan does not turn on, turn the Thermostat Control to the maximum position. The Power Light (D) will remain lit during operation. Setting the Thermostat The thermostat maintains the desired temperature level by switching on and off. Turn the Thermostat Control all the way to the right (clockwise) to the maximum temperature level. [. . . ] AUTO SAFETY SHUT-OFF This heater is equipped with a technologically advanced, safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. It can only resume operation when the user resets the unit. Turn MODE to OFF ( ) and THERMOSTAT to MAX ( ). Tip-Over Protection When the unit is accidentally knocked over, it will instantly shut off. To reset, simply place the heater in an upright position. Safety Back-Up Fuse In the unlikely case the heater does not respond to an overheat situation, the safety back-up fuse will engage. In this case, the heater will not reset. Please contact your local service number on the back of the manual for advice. PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS When using electrical appliances, basic safety precautions should always be taken including the following: 1. Before connecting the heater, check that the voltage indicated on the rating plate corresponds to the main voltage in your home/office. WARNING: In order to avoid overheating, do not cover the heater . A A D B E G C 3. DO NOT position the heater directly under a power socket. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool. If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or similarly qualified person in order to avoid hazard. The heater contains no user serviceable parts. Should the product suffer damage or breakdown, it must be returned to the manufacturer or their service agent. Under the environment with electrical fast transient, the product may malfunction and require user to reset the product. Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. DO NOT position where it can be touched by children, especially the very young. Allow a safe area around the heater away from furniture or other objects; at least 50 cm from the top and sides and 200 cm at the front. Do not use this heater when it is lying on its side. [. . . ] The earth terminal plug is marked with the letter "E", or with the earth symbol or coloured GREEN, or GREEN and YELLOW. 13 amp NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. If a 13A 3-pin plug is fitted, it must be an ASTA approved plug, conforming to BS1363 standard. Replacement 13 A fuses must be BSI or ASTA BS1362 approved. GUARANTEE PLEASE KEEP YOUR RECEIPT AS THIS WILL BE REQUIRED FOR ANY CLAIMS UNDER THIS GUARANTEE · Your heater is guaranteed for 2 years. [. . . ]