User manual BIONAIRE BCH6151

[. . . ] Always unplug the heater when not in use. When unplugging, be sure to pull by the plug and not the cord. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. DO NOT operate heater with a damaged cord or plug, or after the heater malfunctions, has been dropped or damaged in any manner. [. . . ] When your heater is OFF, press the Timer Set button and the numbers will start flashing on the right of the display. Press the ( ) or ( ) buttons to go from 0-24 to set the number of hours that you want your heater to turn On. When the heater turns On, the power light will appear and a small clock will appear on the display to signal the timer is activated. You can turn off the timer by pressing the Timer Button ( ) back to zero, let the heater run to the end of the programmed period or by pressing the Mode Button ( ) before the timer runs out. Before operation, insert 2 "AAA" batteries (not included) into the back of the remote control. fig 2 Mode/On Button Timer Button Oscillation Button · Do not mix old and new batteries. Please note this remote control will not work through walls. POWER: To turn the unit on press the Mode/On Button. To turn the unit off press the Mode/On Button and scroll to OFF. MODES: To scroll through the various modes LO, HI, AL and AH press the Mode/On Button until you reach your desired setting. From there you can press the Temp Up ( ) or Temp Down ( ) Button, which will give you the ability to program the heater to turn on or off in 1 hour increments, up to 24 hours. Carefully remove your heater from the box. Make sure the unit is in the OFF position before plugging the heater into the outlet. Avoid overloading your circuit by not using other high wattage appliances in the same outlet. NOTE: The power light will illuminate when the heater is turned on. To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. if the plug does not fit fully in the outlet , reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Your heater is equipped with a Digital Thermostat that allows you to set your heater to your precise comfort level. While in "Auto" mode, pressing the ( ) or ( ) buttons will adjust the set temperature within a range of 55-85 Fahrenheit or 13-30 Celsius. The LCD display on your heater will display both room and the set temperature while in "Auto" mode. Always unplug the heater before cleaning. [. . . ] Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. jCS disclaims all other warranties , conditions or representations , express , implied , statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. [. . . ]