User manual BIONAIRE BCM6100

[. . . ] When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before using the appliance. Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord under rugs or near heat registers. [. . . ] If the Galileo® Center goes out of range and/or has low batteries, the communication will stop, and after 8 minutes of non-communication the unit will shut off. The power light on the unit will turn on. In this mode, the unit will continuously run at its high setting. Press Mode button on remote a second time for "Med" mode and once again for "Low" mode. Note: While using the remote, the backlight function will turn on when any button is pushed and will turn off after 10 seconds of non-use. Note: Do not block ventilation openings on remote while in use, this may affect the accuracy of the humidity reading. The "Auto" light on unit will illuminate. The unit will cycle on and off to maintain the "Set" humidity at high setting. nOTE: The default room humidity is 45%. In this mode the unit will run to maintain the "Set" humidity. Press Mode button on remote again for "Med" and "Auto", and again for "Low" and "Auto". The unit will cycle on and off to maintain the "Set" humidity at the designated setting. To turn unit "Off", press the Mode button and the LCD will go blank (except for Filter Monitor Fig 3 the "Room" humidity display which is always displayed while batteries are Low in the remote) and the unit Med will shut off. EXTENDED RUN TIME SETTING: By setting you humidifier to a specific humidity level, you are actually also extending the run time. Since the unit will turn on and off to maintain the set humidity level, less water will be used, so you will need to fill the unit less than you would on manual setting. UNIT OPERATION WITHOUT REMOTE Your humidifier can be operated directly from the control panel located on the top of the unit A. Press the Mode button on the unit the first time. The "High" light illuminates and the unit runs in "High" mode. Press the Mode button a second time to run in "Med" mode. Press the Mode button again to run in "Low" mode. Press the Mode button again and the unit shuts off. Note: The "auto" light only illuminates when the unit is set to "auto" mode by the remote. [. . . ] In addition, if you do not follow the recommended care and maintenance instructions, micro-organisms may be able to grow in the water within the humidifier's water tank. Before cleaning, set the mode to the OFF position and unplug the unit from the electrical outlet. Carry the base and the water tank to the sink, remove the filter, then drain and rinse the base and water tank thoroughly to remove any sediment and dirt. Wipe clean and dry with a clean cloth or paper towel. [. . . ]