User manual BIONAIRE BEF6500

[. . . ] pure indoor living Holmes Products (Europe) Ltd. 1 Francis Grove London SW19 4DT England Fax: +44 (0)20 8947 8272 Email: enquiriesEurope@jardencs. com UK - Filter Sales Order Line - 0870 759 9000 Website address: www. bionaire. com UK - Free phone Customer Service Helpline ­ 0800 052 3615 2kW ELECTRIC FIREPLACE HEATER MODEL# BEF6500 INSTRUCTION MANUAL © 2010 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. Distributed by Holmes Products (Europe) Ltd. , 1 Francis Grove, London SW19 4DT, United Kingdom. [. . . ] Screw in two 4 x 35mm screws into the wall plugs, leaving 10mm of the screws out of the wall. Hang the main body of the unit onto the two exposed screws by lining up the rear mounting brackets' holes. Place the securing bottom bracket (P) into the rear of the unit and then use one 4x35mm screw to secure the bracket and unit to the main wall. Add pebbles to the unit, then place the glass panel onto the unit by lining up the glass panel guides with the main housing pins (located on the side of the housing) and make sure the unit is secure. Unit is now ready to be turned on and operated. 3 OPERATING INSTRUCTIONS · There may be an odor coming from the heater the first time you use it. This is normal during the break-in period or after long term storage. Make sure the heater is in a well ventilated area and continue running it until the smell goes away. · You may hear a popping or crackling sound as the heater heats up. · The Fireplace Heater can be operated by using the remote control (Fig. · Place the heater on a firm, level surface or mount on wall. · Avoid overloading your circuit by not using other high wattage appliances in the same outlet. Turn the main ON/OFF switch (N) on the main unit to the ON (­) position. Either press the mode control (K) or the flame intensity button (M) on the main unit or remote control to start the operation of the unit. If for any reason you would like to turn the unit off press the mode button or flame intensity button on the control panel or the ON/OFF Button (Q) on the remote so that no function is heard or visible and then switch the ON/OFF switch on the main unit to the OFF ( ) postion. MODE SETTINGS Once the main ON/OFF switch has been switched to ON, press the mode control button (K) on the panel or remote control: for Fan only setting 1= for continuous low heat (1kW) 2= for continuous high heat (2kW) Press again for no mode operation. THERMOSTAT Note: Thermostat will operate only if the unit is on the Low (1) or High (2) heat setting. Press the digital thermostat button (J) on the control panel or remote enough times to activate one of the 5 preset desired temperature levels (18°C, 21°C, 24°C, 27°C and 30°C). An LED on the unit or the remote control will illuminate to show the selected setting. The thermostat will now maintain the selected temperature level by automatically turning the heater ON and OFF. If the heater cycles ON/OFF frequently select a higher preset temperature. 4. To switch the digital thermostat mode off, press the digital thermostat button until the LEDs on digital thermostat setting on the control panel or remote are no longer lit. [. . . ] Please refer to "Installation of a plug" below. During this guaranteed period, if in the unlikely event the appliance no longer functions due to a design or manufacturing fault, please take it back to the place of purchase, with your till receipt and a copy of this guarantee. Regulate flame brightness using the flame intensity button. Check bulb is working and replace if necessary. This is normal; when the unit is first used or has not been used for a while this sound is caused by dust buildup burning away. [. . . ]