User manual BIONAIRE BFH912

[. . . ] Allow a safe area around the heater away from furniture or other objects; at least 50 cm from the top and sides and 200 cm at the front. Do not use this heater when it is lying on its side. DO NOT use the heater in rooms with explosive gas (e. DO NOT insert any objects into the heater. [. . . ] The digital thermostat has memory, it will remember the last temperature setting before the heater is turned off. However, if the heater is unplugged, the digital thermostat will not longer remember the previous temperature setting. Timer Your model is equipped with a 24 Hour Auto shut-off timer feature. This allows you to programme your heater to shut off automatically after running a defined time interval (from 0-24 hours). Turn the Dial Wheel (+/-) to adjust from 0-24 to select your desired time interval for the heater to shut-off automatically. The selected hour will appear on the LCD display, and then the timer indicator light will stop blinking in 3 seconds to indicate that the selected timer is activated. NOTE: The Timer does not work with the Frost Guard setting. AUTO SAFETY SHUT OFF This heater is equipped with a technologicallyadvanced safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. It can only resume operation when the user rests the unit. If the heater shuts off and the Power Light is flashing, please follow the specific reset instructions below: 1. Unplug unit from socket and wait 30 minutes. NOTE: If the heater is plugged in again and Power On/Off Button is pressed within the 30-minute cool down period, heater will run at High Heat (2) setting, but shut down in 2 seconds with the Power Light flashing. Please repeat the above 3 steps to reset the heater again and ensure to allow sufficient time for the thermostat to cool down. Wait for the heater to cool down sufficiently. You may clean the outside of the heater with a damp cloth. DO NOT allow water to come into the appliance. DO NOT use soap or chemicals, which may damage the housing. Allow sufficient time to dry before plugging the unit back in the socket. Clean the air inlet and outlet openings regularly (with normal use at least twice a year) with a vacuum cleaner. AND IRELAND ONLY If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. [. . . ] press the 1 (LOW) or 2 (HIGH) heat setting button. Raise the temperature higher or change setting to 2 (HIGH) heat. Probable Cause You may hear a popping or crackling sound as the heater heats up. Once the heater heats up, the crackling sound will go away. [. . . ]