User manual BIONAIRE BPH1414

[. . . ] Allow a safe area around the heater away from furniture or other objects; at least 50 cm from the top and sides and 200 cm at the front. Do not use this heater when it is lying on its side. DO NOT use the heater in rooms with explosive gas (e. DO NOT insert any objects into the heater. [. . . ] However, if the unit is unplugged, the digital thermostat resets and no longer remembers the previous temperature setting. Turning the unit on/off and setting the Digital Thermostat (BPH1520 Only) 1. Once you have selected the mode and temperature, the display returns to the current room temperature and gradually increases as the room warms. If you selected an Auto mode and the heater does not start, make sure the set temperature is higher than the current room temperature. To turn the unit off keep pressing the mode button (F) until all mode indicator lights (E) are not illuminated. Switch off the on/off switch located on the bottom of the right end cap. With the heater off, press and hold (+) and (-) simultaneously until the display flashes and display the number "0". Press (+) or (-) to select the amount of time you would like to pass before the heater turns on. After setting the timer, the display shows a red dot next to the current room temperature on the display to indicate that the timer is activated. After the programmed length of time has passed, the heater automatically turns on Auto HI at 24°C (75°F) for 2 hours. With the heater running, press and hold (+) and (-) simultaneously until the display flashes. After setting the timer, the display shows a RED dot next to current room temperature on the display to indicate that the timer is activated. PROGRAMMABLE TIMER (BPH1520 Only) You can program your heater to turn on at a preset time or turn off after a set amount of time. To turn the unit off rotate the mode adjustment knob anti-clockwise to the (0) position. FROST GUARD (BPH1414) Keep unit in 1 (low setting) or 2 (high setting) rotate thermostat adjustment knob to beginning position ( ). In this mode, the heater is off until the room's temperature reaches freezing and the heater automatically turns on HI power. This special setting is automatically activated when the (AF) mode is selected. In this mode, the heater is off until the room's temperature reaches freezing and the heater automatically turns on HI power. AUTO SAFETY SHUT OFF The heater has a built in safety device which will switch off the heater automatically in case of accidental overheating. It can only resume operation when the user has reset the unit. SAFETY BACK-UP FUSE In the unlikely case the heater does not respond to an overheat situation, the safety back-up fuse will engage. In this case, the heater will not reset. [. . . ] WARNING ­ THIS APPLIANCE MUST BE EARTHED The wires in the mains lead are coloured as such: GREEN AND YELLOW EARTH BROWN LIVE BLUE NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows: The wire which is coloured GREEN AND YELLOW must be connected to the terminal which is marked with the letter "E" or by the earth symbol or GREEN AND YELLOW. The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. [. . . ]