User manual BIONAIRE BU1300W

[. . . ] BU1300WIUK06EM1. qxd 9/18/06 11:24 AM Page 1 NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. If a 13A 3-pin plug is fitted, it must be an ASTA approved plug, conforming to BS1363 standard. Replacement 3A fuse must be BSI or ASTA BS1362 approved. GUARANTEE PLEASE KEEP YOUR RECEIPT AS THIS WILL BE REQUIRED FOR ANY CLAIMS UNDER THIS GUARANTEE. [. . . ] NEVER tilt, move, or attempt to empty unit while it is operating. Shut off and unplug before removing the water tank and moving the unit. DO NOT attempt to remove the water tank within 15 minutes after the humidifier is turned off and unplugged. Serious injury may result. · · Excessive humidity in a room can cause water condensation on windows and some furniture. If this happens, turn the humidifier OFF Do not use humidifier in an area where humidity level is in excess of 55%. PRE-OPERATING INSTRUCTIONS 1. Be sure the humidifier is disconnected from the wall outlet and humidity control switch (C) is in the off position ( ). Remove the tank lid and fill with cool, fresh tap water. Place the water tank (E) on the base (D). If the humidifier is not level always turn the power off before handling it. Plug the power cord into a convenient electrical outlet. Power/Night light (B) will illuminate when the unit is operating. When the unit is out of water or when the unit is switched off, the Power/Night light will not be working. Turn your humidifier on by rotating the humidity control switch (C) to the high position It will take a few minutes before full moist air output is obtained. Please note the mist will only be visible and humidifying between the moisture droplet marks shown on your humidifier (Min - Max ). Power/night light (B) will illuminate when humidifier is connected to main electrical power and the humidifier is switched on. To reduce the speed at which the vapour is emitted, turn the humidity control switch towards the low position ( ). Rotate the humidity control switch from low to high to regulate the mist output. Rotate the mist nozzle (A) to the desired mist direction. When the unit runs out of water, the transducer will automatically shut off. Turn the humidity control switch anti-clockwise to the off ( ) position, then unplug the unit. Before refilling the tank, empty any residual water and follow the Daily maintenance instructions. Refill the water tank with cool tap water and replace onto the base. [. . . ] Open the water tank and place the appliance in a cool area for 12 hours. Wash the humidity control and change the water. Clean the transducer softly with a damp cotton ball. Transducer surface is delicate, avoid applying excessive pressure. [. . . ]