User manual BISSELL MOMENTUM CYCLONIC

[. . . ] Momentum Cyclonic BAGLESS VACUUM USER'S GUIDE 3910 SERIES 220-240V 3 Safety Instructions Product View Assembly Operation Maintenance and Care Troubleshooting Consumer Services Replacement Parts Warranty 4 5-6 6-9 10-16 17 18 19 20 ug603-2377_3910E_207. indd 1 2/7/07 4:03:31 PM Thanks for buying a BISSELL vacuum We're glad you purchased a BISSELL vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL vacuum is well made, and we back it with a limited one year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Services department, so, should you ever have a problem, you'll receive fast, considerate assistance. [. . . ] For your convenience, there are two quick release cord wraps for easy cord removal. There is also a cord clip that is part of the upper cord wrap where you can attach the cord when vacuuming. When you are finished cleaning, turn vacuum cleaner off. Unplug power cord by grasping the plug (NOT the cord) and disconnect from outlet. Loop power cord around cord wraps on rear of vacuum cleaner. Be sure to first return the quick release cord wraps back to their original position before wrapping the cord. Unplug the vacuum from electrical outlet 3. 2. 4. Slide the Lock `n Seal Lever to the "Unlock" position. Grasp handle and pull the dirt container straight out to remove from the vacuum. Empty dirt into garbage container. NOTE: Emptying the dirt container after every use will help prevent overfilling and ensure that the vacuum is ready to go the next time you clean. 4. Unlock 10 www. bissell. com ug603-2377_3910E_207. indd 10 2/7/07 4:03:43 PM Maintenance and care Cleaning the pre-motor and post-motor HEPA media filter 1. Unplug the vacuum from electrical outlet. The pre-motor filter protects the motor from dirt particles. It is located in the slide out tray underneath the dirt container. If the filter becomes dirty, pull out the tray, lift out the foam filter pad and clean it. NOTE: The pre-motor filter may be hand washed in cold water with mild detergent. Rinse well and air dry thoroughly before replacing. The post-motor HEPA media filter Washable assists in the filtration process to Pre-Motor return clean air to the room. It is Filter located behind the door on the side of the vacuum. If the filter becomes dirty, open the door, remove the filter and replace. NOTE: The post-motor filter is a white, pleated HEPA media filter. This filter is NOT washable and must be replaced when it becomes dirty. Post-Motor HEPA Media Filter 3. WARNING: Do not operate vacuum cleaner with damp or wet filters or without all filters in place. www. bissell. com 11 2/7/07 4:03:44 PM ug603-2377_3910E_207. indd 11 Maintenance and care Check rotating floor brush and drive belt You should check your vacuum cleaners rotating floor brush and drive belt regularly for wear or damage. You should also clean the brush and brush ends of strings, hair and carpet fibers. [. . . ] Filters missing or installed incorrectly 3. Dirt container installed incorrectly Remedies 1. Check pre-motor and post-motor filters for correct installation 3. Pull out and re-insert dirt container correctly Other maintenance or service not included in the manual should be performed by an authorized service representative. Thank you for selecting a BISSELL product. Please do not return this product to the store. www. bissell. com 17 2/7/07 4:03:47 PM ug603-2377_3910E_207. indd 17 BISSELL Consumer Services If your BISSELL product should require service: In the UK, Australia, or New Zealand, call BISSELL Consumer Services at the numbers below and we will give you the location of a BISSELL Authorized Service Center in your area. [. . . ]