User manual BISSELL POWERBRUSH SELECT

[. . . ] PowerWashTM Powerbrush Select USER'S GUIDE 1623 SERIES 220-240V 3 Safety Instructions 4 Product View 5 Assembly 6 Special Features 7-11 Operation 12 Maintenance and Care 13 Troubleshooting 14 Consumer Services 15 Replacement Parts 16 Warranty ug120-4039_1623E_508. indd 1 5/19/08 12:28:42 PM Thank you for buying a BISSELL deep cleaner We're glad you purchased a BISSELL deep cleaner. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. By purchasing this product you are helping BISSELL with our commitment to reducing our impact on the environment through an expanding range of sustainable design efforts. Your deep cleaner is well made, and we back it with a limited one-year warranty. [. . . ] Set the ReadyTools dial to the TOOLS setting. This will allow spray and suction from the hose. Attach the desired cleaning tool to the end of the hose. Clean by pressing the spray trigger to spray solution onto the area to be cleaned. Slowly move the tool back and forth over the soiled surface. Release the spray trigger to suction dirty water. Continue to clean in the area, working in small sections, until dirt is removed. Caution: Do Not Overwet. 7. Manufacturer's tag bvh g kvh gh j j h d b lg fd hn l kl sd jkn f h A d bj jh bj cv hh gcg 2. 3. Tip: To clean with sliding crevice tool, slide brushes forward to clean stain, slide back to suction 4. When finished cleaning, remove and rinse tool(s) in clean, running water. It is recommended that you suction clean water from the tap to rinse out the hose. Before wrapping hose onto tool rack, lift end of hose and stretch out to ensure all water is cleared from hose. www. bissell. com 9 5/19/08 12:30:00 PM ug120-4039_1623E_508. indd 9 Operation Ready ToolsTM cleaning with attachments continued 13. Empty 2-in-1 water tank and rinse out, following instructions on page 8. If the ReadyTools dial becomes difficult to turn, the diverter assembly that holds the dial may need to be cleaned. To clean, first remove nozzle and locate screw that holds the diverter assembly in place. With a Phillips screwdriver, remove the screw and set aside. Remove diverter assembly; hold under running water making sure water flows through and around the dial. Turn the dial about 10 times clockwise and 10 more times counter clockwise. Wipe diverter assembly with a soft cloth and replace back on machine by screwing back into place. Return ReadyTools dial to FLOOR CLEANING setting. 16. Screw Hard Floor Cleaning Your deep cleaner may have come with a hard floor tool and Hard Floor Solutions Formula. The hard floor tool provides effective cleaning for linoleum, vinyl, and tile floors. [. . . ] 2-in-1 water tank is not properly seated. 2-in-1 water tank has picked up maximum dirty water. Empty tank and refill, refer to the Operation section. Refer to page 8. Other maintenance or service not included in the manual should be performed by an authorized service representative. Thank you for selecting a BISSELL product. Please do not return this product to the store www. bissell. com 13 5/19/08 12:30:04 PM ug120-4039_1623E_508. indd 13 BISSELL Consumer Services If your BISSELL product should require service: In the UK, Australia or New Zealand, call BISSELL Consumer Services at the numbers below and we will give you the location of a BISSELL Authorized Service Center in your area. For all other countries, contact your local in country distributor for questions, service, or repair. [. . . ]