User manual BLACK & DECKER ASI500

[. . . ] If you have a question or experience a problem with your Black & Decker purchase, go to If you can't find the answer or do not have access to the internet, call 1-800-544-6986 from 8 a. Please have the catalog number available when you call. Read all instructions before operating product. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] This will reduce risk of damage to electric plug and cord. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. Do not operate charger with a damaged cord or plug. Do not operate the charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Incorrect reassembly may result in a risk of electric shock, electrocution or fire. Never use another products charger to charge this product. Always use identical replacement parts only. LIQUID CRYSTAL DISPLAY FLUID (FIRST AID MEASURES) If liquid crystal comes in contact with your skin: Wash area off completely with plenty of water. If liquid crystal gets into your eye: Flush the affected eye with clean water and then seek medical attention. If liquid crystal is swallowed: Flush your mouth thoroughly with water. drink large quantities of water and induce vomiting. The label on your tool may include the following symbols. Your Black & Decker inflation station is designed to be used cordless or in most vehicles from the standard 12 Volt socket to inflate car and bike tires, balls, rafts, air mattresses, swimming pool floats, etc. This product is intended for household, consumer use only. CHARGING THE BATTERY - FIGURE A A The internal battery must be recharged for 4 to 5 hours using the AC charger provided (13). â· Insert the jack plug (9) into the socket on the front of the unit (11). Red, unit charging, Green, unit charged. â· When fully charged, remove the AC charger from the power source and remove the jack plug from the unit. Wrap the 12v dc cord (17) around the base of the unit and snap the 12 Vdc adapter (8) into its storage location on the base of the unit (16). The air hose (5) is located in a storage channel around the top of the unit (fig. C), make sure the hose is snapped into the retaining clips and the lever is in the up position (fig. The pump hose (7) is stored around the center of the unit and snaps into position at both ends. [. . . ] Help protect our environment and conserve natural resources by returning the spent lead acid battery to an authorized Black & Decker service center or to your local retailer for recycling. You may also contact your local recycling center for information on where to drop off the spent battery, or call 1-800-8-BATTERY. Accessory socket not live Main ON/OFF switch not in correct position. Replace the fuse with one of the same size and type (8A/250V). [. . . ]