User manual BLACK & DECKER BBC2CB

[. . . ] Also use a hard hat, hearing protection, gloves, safety shoes and dust collection systems when specified or required. Safety glasses or the like are available at extra cost at your local dealer or Black & Decker Service Center. Never carry appliance by cord or yank it to disconnect from receptacle. Keep cord from heat, oil, and sharp edges. [. . . ] Read and understand all warnings and operating instructions before using any tool or equipment. WARNING: BURST HAZARD: Do not use the unit for charging dry-cell batteries that are commonly used with home appliances. These batteries may burst and cause injury to persons and damage property. Use the unit for charging/boosting a LEAD-ACID battery only. It is not intended to supply power to a low-voltage electrical system other than in a starter-motor application. cAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: · Do not operate unit with damaged cord or plug; or if the unit has received a sharp blow, been dropped, or otherwise damaged in any way. Do not disassemble the unit; take it to a qualified service technician when service or repair is required. ⷠNEVER submerge this unit in water; do not expose it to rain, snow or use when wet. ⷠMake sure cord is located so that it will not be stepped on, tripped over or otherwise subjected to damage or stress. ⷠDo not leave the unit unattended while attempting to boost a vehicle. Pull cord by plug rather than cord when disconnecting the unit. Before boosting, read the vehicle's owner's manual to confirm that external-starting assistance is suitable. ⷠDo not use any accessory that is not recommended or provided by the manufacturer. ⷠThis system is designed to be used only on vehicles with a 12 volt DC battery system. Excessive engine cranking can damage a vehicle's starter motor. If the engine fails to start after the recommended number of attempts, discontinue boosting procedures and contact a qualified technician to investigate why the engine did not start. ⷠDo not use this battery booster on a watercraft. Follow these instructions and those published by the battery manufacturer and manufacturer of any equipment you intend to use with this unit. This car to car booster is an innovative product that replaces the use of inconvenient booster cables to jump-start a car. All you need to do is to insert one end of the cable to the cigarette lighter socket of a working car, and the other end to the car that needs to be boosted. Vehicle-to-vehicle boosting without the trouble of traditional cables Compact and convenient LED status indicators Built-in Storage Cylinder Insert the Black 12 Volt DC Accessory Plug into the 12 volt DC accessory outlet of the working car. Rotate the plug slightly to make sure there is good contact. [. . . ] Before boosting this type of vehicle, read the vehicle manual to confirm that external-starting assistance is advised. ⷠExcessive engine cranking can damage the vehicle`s starter motor. If the engine fails to start after the two attempts, discontinue boosting procedure and contact a qualified technician to investigate why the engine did not start. Store and use this battery booster in dry areas and avoid extremely high temperatures. [. . . ]