User manual BLACK & DECKER BH32EK

[. . . ] Wear protective hair covering to keep long hair out of the way. 8 Wear safety goggles Also use a face or dust mask in case the operations produce dust or flying particles. 9 Beware of maximum sound pressure Take appropriate measures for the protection of hearing if the sound pressure of 85 dB(A) is exceeded. 11 Do not overreach Keep proper footing and balance at all times. [. . . ] Have damaged guards or other defective parts repaired or replaced as instructed. 20 Have your tool repaired by an Elu authorized repair agent This Power Tool is in accordance with the relevant safety regulations. Your Elu heavy duty rotary hammer drill BH32EK has been designed for professional rotary drilling and hammer drilling as well as light chipping, chiselling and demolition applications and for carbide-tipped core drilling. 1 Variable speed switch 2 Tool holder for SDS-plus® accessories 3 Mode selector with safety lock 4 Side handle 5 Depth adjustment rod 6 Depth stop clamp Torque limiting clutch All rotary hammer drills are equipped with a torque limiting clutch that reduces the maximum torque reaction transmitted to the operator in case of jamming of a drill bit. This feature also prevents the gearing and electric motor from stalling. the torque limiting clutch has been factory-set and cannot be adjusted. Variable speed The variable speed feature allows speed to build up slowly, thus preventing the drill bit from walking off the intended hole position when starting. Always check that the power supply corresponds to the voltage on the rating plate. Your Elu tool is double insulated in accordance with EN 50144; therefore no earth wire is required. Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an Elu authorized repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. B) The rotary hammer drill can be used in two operating modes: Never use a light socket. Never connect the live (L) or neutral (N) wires to the earth pin marked E or . For 115 V units with a power rating exceeding 1500 W, we recommend to fit a plug to BS4343 standard. Rotary drilling: for drilling into metal, wood and plastics Hammer drilling: simultaneous rotating and impacting for concrete and masonry drilling and carbide-tipped core drilling · Select the required operating mode by depressing the safety lock (8) and rotating the mode selector (3) towards the symbol on the housing until the safety lock clicks into position. Do not select the operating mode when the tool is running. [. . . ] If you are not completely satisfied with the performance of your Elu tool, simply return it within 30 days, complete as purchased, to your Elu dealer for a full refund or exchange. Accessories and attachments used must be regularly lubricated around the SDS-plus® fitment. Cleaning Keep the ventilation slots clear and regularly clean the housing with a soft cloth. If your Elu product becomes defective due to faulty materials or workmanship within 12 months from the date of purchase, we guarantee to replace all defective parts free of charge or, at our discretion, replace the unit free of charge provided that: · Unwanted tools and the environment Take your tool to an Elu authorized repair agent where it will be disposed of in an environmentally safe way. [. . . ]