User manual BLACK & DECKER BHA24

[. . . ] Years of experience, thorough product development and innovation make Elu one of the most reliable partners for professional Power Tool users. The following symbols are used throughout this manual: Denotes risk of personal injury, loss of life or damage to the tool in case of nonobservance of the instructions in this manual. Voltage No load speed Load speed Impact energy Maximum drilling range in steel/wood/concrete Tool holder Collar diameter Weight (without battery pack) Battery pack Voltage Weight Charger Mains voltage Approx. For more information, please contact Elu at the address below, or refer to the back of the manual. [. . . ] Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. Always switch off the tool before inserting or removing the battery pack. Before using the tool, make sure the battery pack is properly seated. If the mains is functioning but the battery pack does not charge, take your charger to an authorized Elu repair agent. whilst charging , the charger and the battery pack may become warm to touch. This is a normal condition and does not indicate a problem. Do not charge the battery pack at ambient temperatures < 4 °C or > 40 °C. To charge the battery pack (9), insert it into the charger (10) as shown and plug in the charger. Be sure that the battery pack is fully seated in the charger. 1 hour, it will stop blinking and remain on. The battery pack is now fully charged and the charger automatically switches to equalization mode. The battery pack can be removed at any time or left in the connected charger indefinitely. Reinsert the battery pack or try a new one. If the new pack also refuses to charge, have your charger tested by an authorized Elu repair agent. When plugged into power sources such as generators or sources that convert DC to AC, the red charging indicator (11) may blink twice, switch OFF and repeat. This indicates a temporary problem of the power source. It is therefore recommended to use the refresh mode weekly or every 10 charge/discharge cycles. Please make sure to use the feature whenever you notice decreased battery pack performance. The red charging indicator will stop blinking momentarily, quickly blink three times and then resume blinking as before. [. . . ] Insert the special SDS-plus screwdriving adaptor for use with hexagonal screwdriver bits. When driving slotted head screws always use bits with a finder sleeve. Gently press the variable speed switch (1) to prevent damage to the screw head. In reverse (LH) rotation the tool speed is automatically reduced for easy screw removal. [. . . ]