User manual BLACK & DECKER BS45EK

[. . . ] ) electric safety can be improved by inserting an isolating transformer or a (FI) earth-leakage circuit-breaker. 4 Keep children away Do not let children come into contact with the tool or extension cord. Supervision is required for those under 16 years of age. 5 Extension cords for outdoor use When the tool is used outdoors, always use extension cords intended for outdoor use and marked accordingly. [. . . ] Your BS40EK/BS40EKN drywall screwdriver has been designed for driving drywall fasteners through drywall board into timber or metal framing studs. 5 Ball retainer (BS10EK/BS45EK) 6 Belt clip Dead spindle drive clutch This screwdriver is equipped with a dead spindle feature; the spindle does not turn until the fastener is pressed into the workpiece. This enables fasteners to be placed onto the drive accessory of a running screwdriver. Never connect the live (L) or neutral (N) wires to the earth pin marked E or . For 115 V units with a power rating exceeding 1500 W, we recommend to fit a plug to BS4343 standard. If an extension cable is required, use an approved extension cable suitable for thepower input of this tool (see technical data). When using a cable reel, always unwind the cable completely. Always check that the power supply corresponds to the voltage on the rating plate. Your Elu tool is double insulated in accordance with EN 50144; therefore no earth wire is required. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an Elu authorized repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. A bit holder or nutsetter) (7) push it into the holder (8) until it snaps in place. To remove the accessory pull it out of the holder using a pair of pliers. Reinstall the collar (4) by aligning the ribs (9) on the inside of the collar (4) with the grooves (10) in the clutch housing and snap the collar in place. Pull the ball retainer (5) to the front and hold it. bS20EK/BS25EK/BS40EK/BS40EKN Setting the driving depth (fig. C) The depth sensitive feature offers the following advantages: - the selected driving depth is repeatable for structural integrity - screws with sealing washers are driven correctly so that no leaks occur The driving depth is determined by the position of the depth locator (5) in relation to the bit or socket. The symbols on the collar indicate how to set the driving depth. [. . . ] bS40EK/BS40EKN · Regularly remove drywall dust from the clutch housing using compressed air. Take your tool to an Elu authorized repair agent where it will be disposed of in an environmentally safe way. All Elu Power Tools are thoroughly tested before leaving the factory. However, if the Power Tool needs repair, please contact your dealer or the Elu Head Office for the address of the nearest Elu authorized repair agent (please refer to the back of this manual). [. . . ]