User manual BLACK & DECKER BV3600

[. . . ] If you have a question or experience a problem with your Black & Decker purchase, go to WWW. If you cant find the answer or do not have access to the internet, call 1-800-544-6986 from 8 a. Please have the catalog number available when you call. â· Before operating, make sure that either the blower or vacuum tube assembly is locked in place. [. . . ] To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This equipment must be used with a suitable polarized 2 wire or 3 wire extension cord. Polarized connections will fit together only one way. Make sure that the receptacle end of the extension cord has large and small blade slot widths. If the plug does not fit fully into the extension cord, reverse the plug. if it still does not fit , obtain a suitable extension cord. If the extension cord does not fit fully into the outlet, contact a qualified electrician to install the proper outlet. Do not change the tool plug or extension cord in any way. WARNING: Before attempting any of the assembly steps below, ensure product is switched off and disconnected from the power supply. Ensure grill cover is attached to the power head. If not, attach cover as shown in the inset of figure 1. NOTE: Unit will not operate in blow mode without grill cover in place. Align the upper and lower tubes as shown in figure 1. â· Blow tubes must be assembled to the power head before use. â· Never operate without both lower and upper tubes assembled. â· In the interest of safety, it is not intended for the tubes to be separated once assembled. â· Push the lower tube firmly into the upper tube, until the tubes click into place. Push the tube assembly onto the power head until it is in the fully locked position (figure 2). Use the air concentrator attachment to target air flow to a tighter area. add the attachment to the assembly as shown in figure 3. Push on until hole in tab engages raised post on tube. Attach the shoulder collection bag to the power head as shown in figure 4. [. . . ] â· Attach the vacuum tube assembly to the power head (figure 7) by locating the assembly as indicated by arrow, then pivot about this point until the locking/release catch is fully engaged. â· Connect the cord on the power head to the power supply (figure 10). Turn the 12 blower/vac on, then using a sweeping motion the debris/leaves will be sucked up the tube, mulched and deposited into the collection bag (figure 12) . As the bag fills the power of the suction will decrease, switch off your product and unplug from power supply. [. . . ]