User manual BLACK & DECKER DN402

[. . . ] GK1630T GK1635T GK1640T English (Original instructions) 6 2 3 4 5 Intended use Your Black & Decker chainsaw has been designed for pruning and felling trees and cutting logs. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning!Read all safety warnings and all instructions. [. . . ] Electric safety can be further improved by using a high-sensitivity (30 mA/ 30mS) Residual Current Device (RCD). The use of an RCD or other circuit breaker unit does not release the operator of your chainsaw from the safety instructions and safe working practices given in this user manual. Guard against electric shock u Avoid cutting @ Vibration The declared vibration emission values stated in the technical data and the declaration of conformity have been measured in accordance with a standard test method provided by EN 60745 and may be used for comparing one tool with another. The declared vibration emission value may also be used in a preliminary assessment of exposure. Always remove the plug from the socket before inspecting a damaged cable. Be careful not to use your chainsaw if the cable is damaged. You must do this whenever you use a new chain (6) for the first time. Take the new chain (6) and soak it in chain oil for at least an hour before using it. We recommend that you use only Black & Decker oil during the lifetime of your chainsaw because mixtures of different oils could lead to the oil becoming degraded, which can drastically shorten the lifetime of the saw chain and create additional risks. Never use waste oil, thick oil or very thin sewing machine oil. A - E) u u Place the chainsaw onto a stable surface. Set the front guard/chain brake assembly to the forward position (fig. U Remove the chain cover assembly (10). 9 Place the chain (6) over the guide bar (7) making sure that the saw chain cutters on the upper part of the guide bar (7) face towards the front (fig. U Guide the chain (6) around the guide bar (7) and pull it to create a loop to one side at the rear end of the guide bar (7). U Guide the chain (6) around the drive sprocket (12). Place the guide bar (7) onto the bar location studs (13) (fig. U u Allow the control knob to spring back to the „out“ position and rotate further clockwise to tighten the guide bar. Make sure that the front guard/chain brake assembly (4) is in the set (forward) position before refitting (fig. Before fitting the chain cover assembley check that the cam (11) (fig. If necessary, press in and turn the control knob (9) clockwise to rotate the cam into the correct position. U Fit the chain cover by locating the bolt and using the control knob (9) to tighten the chain cover finger tight. [. . . ] Technical data Bar length cm Voltage VAC Power input W Chain speed (no load) m/s Max cutting length cm Oil capacity ml Weight kg Safety class Bar length cm Voltage VAC Power input W Chain speed (no load) m/s Max cutting length cm Oil capacity ml Weight kg Safety class GK1630T Typ. 8 II z Separate collection of used products and packaging allows materials to be recycled and used again. Re-use of recycled materials helps prevent environmental pollution and reduces the demand for raw materials. 9 II Level of sound pressure according to EN 60745: Sound pressure (LpA) 92 dB(A), uncertainty (K) 3 dB(A) Sound power (LWA) 103 dB(A), uncertainty (K) 3 dB(A) Vibration total values (triax vector sum) according to EN 60745: Vibration emission value (ah) 5 m/s2, uncertainty (K) 1. [. . . ]