User manual BLACK & DECKER EGBL108-FR

[. . . ] EGBL108 A B C D E 2 (Original instructions) Intended use Your Black & Decker drill/screwdriver has been designed for screwdriving applications and for drilling in wood, metal and plastics. This tool is intended for consumer use only. ENGLISH Safety instructions General power tool safety warnings @ Warning!Read all safety warnings and all instructions. [. . . ] The vibration level may increase above the level stated. When assessing vibration exposure to determine safety measures required by 2002/44/EC to protect persons regularly using power tools in employment, an estimation of vibration exposure should consider, the actual conditions of use and the way the tool is used, including taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time. Chargers u Use your Black & Decker charger only to charge the battery in the tool with which it was supplied. Other batteries could burst, causing personal injury and damage. $ # The charger is intended for indoor use only. Electrical safety Your charger is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the rating plate. Never attempt to replace the charger unit with a regular mains plug. U Labels on tool The following symbols are shown on the tool: If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. Additional safety instructions for batteries and chargers Batteries u Never attempt to open for any reason. U Do not store in locations where the temperature may exceed 30 °C. U Charge only at ambient temperatures between 4 °C and 40 °C. U Charge only using the charger provided with the tool. U When disposing of batteries, follow the instructions given in the section "Protecting the environment". To reduce the risk of injury, the user must read the instruction manual. Features This tool includes some or all of the following features. Before assembly, remove the battery from the tool. To fit the battery (5), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place. U To remove the battery, push the release button (9) while at the same time pulling the battery out of the receptacle. 5 ENGLISH (Original instructions) Charger diagnostics If the charger detects a weak or damaged battery, the charging indicator (8) will flash red at a fast rate. proceed as follows: u Re-insert the battery (5). [. . . ] Uk to register your new Black & Decker product and to be kept up to date on new products and special offers. Further information on the Black & Decker brand and our range of products is available at www. Un alimentatore idoneo a un determinato battery pack potrebbe essere causa di incendio se usato con un battery pack diverso. Vid garantianspråk ska produkten och inköpskvittot lämnas till återförsäljaren eller till en auktoriserad verkstad. [. . . ]