User manual BLACK & DECKER GH750

[. . . ] Unplug unit if cord is damaged or tangled Flying debree, keep your distance Unplug unit before cleaning or repairing Do not expose to rain Keep bystanders away Mantenha as pessoas afastadas na hora da operação Sempre utilize óculos de proteção Always wear safety glasses Before any use, be sure everyone using this tool reads and understands all safety instructions and other information contained in this manual. Save these instructions and review frequently prior to use and in instructing others. WARNING: When using electric gardening appliances, basic safety precautions should always be followed to reduce risk of fire, electric shock, and personal injury, including the following: Than the other) and will require the use of a polarized extension cord. The appliance plug will fit into a polarized extension cord only one way. [. . . ] A damaged cord must be replaced before further use. DISCONNECT TOOL ­ when not in use, when replacing line, or prior to cleaning. Follow all instructions in this Instruction Manual for proper operation of your tool. Motors in these tools normally spark, and the sparks might ignite fumes. STORE IDLE TOOLS INDOORS ­ When not in use, tools should be stored indoors in a dry, locked-up place out of reach of children. GROUND FAULT CIRCUIT INTERRUPTER (GFCI) protection should be provided on the circuits or outlets to be used for the gardening appliance. Receptacles are available having built in GFCI protection and may be used for this measure of protection. Keep handles dry, clean and free from oil and grease. CHECK DAMAGED PARTS ­ Before further use of the appliance, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other condition that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated elsewhere in this manual. Attach the handle to the metal shaft of the trimmer (with the Black & Decker logo facing upward) by pushing it onto the shaft from the side. Once it is pushed onto the metal shaft, the handle can be turned into the correct orientation . 5mm) bolt through the holes in the handle and thread on the plastic knob as shown in figure 5. Shorter users adjust handle to a lower position (away from you) and taller users, adjust handle to an upper position (towards you). The handle should be adjusted so that your front arm is straight when the trimmer is in the working position. The overall height of the trimmer can be adjusted by pressing the button shown in figure 6 and moving the metal tube up or down into one of the three rectangular recesses in the tube until you hear it "snap" into place. CAUTION: Confirm that the tube is locked in place by releasing the button and pushing down on the tube. An extension cord retainer (figure 7) is built into the switch handle that prevents the cord from coming unplugged. To use this feature, simply double the extension cord about 8 inches (203mm) from the end, and insert it into the slot in the bottom of the handle area. WARNING: Always use proper eye protection that conforms to ANSI Z87. CAUTION: Inspect area to be trimmed and remove any wire, cord, or string-like objects which could become entangled in the rotating line or spool. [. . . ] The line should protrude approximately 4-3/8 inches (111mm) from the cassette. Push the cassette onto the housing until it snaps securely into place. CAUTION: To avoid tool damage, If the cutting lines protrude beyond the trimming blade (i), cut them off so that they just reach the blade (figure 10). You may wind new cutting line onto an empty spool. [. . . ]