User manual BLACK & DECKER GL300

[. . . ] â· DO NOT FORCE THE TOOL -- at a rate faster than the rate at which it is able to cut effectively. â· USE THE RIGHT TOOL -- Do not use this tool for any job except that for which it is intended. WARNING -- To prevent electric shock hazard, use only with an extension cord suitable for outdoor use. Always connect extension cords to a fused line or one protected by a circuit breaker. [. . . ] Carefully remove the protective cover of the blade before using. note: This tool is intended for light applications. It is recommended to use it from 15 to 20 minutes maximum per time. Any excessive use could cause damage in the tool. Edging Procedure Caution: Inspect area to be trimmed for any wire, cord, or string-like matter which could become entangled in the rotating line or spool. Be particularly careful to avoid any wire which might be bent outwardly into the path of the tool, such as barbs at the base of a chain link fence. Push the lock button on the upper body to the left and pull out the handle. Rotate the trimmer handle and insert in this position on the lower body. Move the lock on button to the left and push down until being able to move the lock on button to the right. Rotate counterclockwise the knob located on the lower body to release and pull up the upper body to adjust the telescoping shaft until suit your height comfortably. Line Feeding Procedure In order to feed a length of cutting line, strike the bump cap on the lawn while the trimmer is running. This will automatically feed a new length of line and trim it to the correct length. A firm but gentle motion should be used to strike the bump cap. The unit should be angled slightly forward to prevent the guard from contacting the ground. This process may be repeated as often as necessary. If unit fails to feed, unplug extension cord at trimmer and clean out the bump cap. trimming Technique and Performance Notes Tilt trimmer at a slight angle from the ground. Lower to grass or weeds you intend to cut. (If they are over 20cm (8") high , start cutting at top. ) Slowly swing unit into and out of area being cut, holding the unit off the ground at desired cutting height. IMPORTANT: for the best cutting action against walls, fences and in high grass, move trimmer slowly so grass is cut WITH THE TIP of the high speed nylon line. Avoid running trimmer with hub in contact with ground. [. . . ] If trimmer still fails to operate, take or send it to your local B&D service center or authorized service station for repair. Important To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (including brush inspection and replacement) should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts. Accessories Replacement line is available from your local dealer, or a Black & Decker service center. Recommended accessories for your trimmer are shown in this manual. [. . . ]