User manual BLACK & DECKER GL9035

[. . . ] GL7033 GL8033 GL9035 A B C D E 2 F G H I J 20 O K L 3 M N O P 4 (Original instructions) ENGLISH Intended use Your Black & Decker trimmer has been designed for trimming and finishing lawn edges and to cut grass in confined spaces. This appliance is intended for consumer use only. safety of others u Safety instructions Warning!When using mains-powered appliances, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock, personal injury and material damage. [. . . ] U (Original instructions) ENGLISH Features This appliance includes some or all of the following features. Edge wheel Adjusting the height of the tool (fig. E & F) This tool has a telescopic mechanism, allowing you to set it to a comfortable height. To adjust the height setting, proceed as follows: u Release the height adjust locking clamp (16). U Gently pull the tube (7) up or down to the desired height. u Close the height adjust locking clamp (16). Releasing the cutting line In transit, the cutting line is taped to the spool housing. U Remove the tape holding the cutting line to the spool housing (12). Before assembly, make sure that the tool is switched off and unplugged. A & B) u u Remove the screw (15) from the guard (10). Place the guard (10) onto the tool as shown. U Firmly press the guard until it snaps into place. Never use the tool unless the guard is properly fitted. Press in and hold the adjustment button (6) on the side of the main body. U Slide the secondary handle (5) in place over the adjustment button (6). Ensure that the teeth on the button are correctly aligned in slots in the handle and that the handle is secure. u The tool has two cutting systems:. U AFS: Single line autofeed for light trimming and edging. u HDL: Heavy Duty Dual Line cutting system for more overgrown areas. Note: The HDL spool may be used in trimming mode only. The cutting system not in use can be stored in the spare spool storage (GL8033 & GL9035 Only). U Align the tabs (17) on the spool cover with the cut outs (18) in the spare spool storage (8). [. . . ] Uk to register your new Black & Decker product and to be kept up to date on new products and special offers. Further information on the Black & Decker brand and our range of products is available at www. Uk GL7033/GL8033/GL9035 Black & Decker declares that these products described under "technical data" are in compliance with: 2006/42/EC, EN 60335-1, EN 60335-2-91 2000/14/EC, Lawn Trimmer, L ≤ 50 cm, Annex VIII KEMA Quality B. : 0344 Level of sound power according to 2000/14/EC (Article 12, Annex III, L ≤ 50 cm): LWA (measured sound power) 94 dB(A) uncertainty (K) = 2 dB(A) LWA (guaranteed sound power) 96 dB(A) uncertainty (K) = 2 dB(A) These products also comply with directive 2004/108/EC and 2011/65/EU. [. . . ]