User manual BLACK & DECKER GPC1820L

[. . . ] Australia GPC1820L-XE New Zealand www. blackanddecker. com. au 24 12 2 3 ENGLISH (Original instructions) 3. Personal safety a. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. [. . . ]  Children should be supervised to ensure that they do not play with the appliance. Vibration The declared vibration emission values stated in the technical data and the declaration of conformity have been measured in accordance with a standard test method provided by EN 60745 and may be used for comparing one tool with another. The declared vibration emission value may also be used in a preliminary assessment of exposure. The vibration emission value during actual use of the power tool can differ from the declared value depending on the ways in which the tool is used. The vibration level may increase above the level stated. When assessing vibration exposure to determine safety measures required by 2002/44/EC to protect persons regularly using power tools in employment, an estimation of vibration exposure should consider, the actual conditions of use and the way the tool is used, including taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time. Pruning Before attempting to prune a tree, ensure there are not bylaws or regulations that would prohibit or control the felling of the tree.  Be aware of the direction a branch may fall. Consider all conditions that may affect the direction of fall, including: - the length and weight of the branch to be cut - the intended direction of fall - any unusual heavy limb structure or decay - the presence of surrounding trees and obstacles, - including overhead lines - the intertwinement with other branches - the speed and direction of the wind. 6 Beware of falling objects. Keep at least 10 m away from overhead lines. To ensure continued safe operation, check the chain tension as described in this manual after every 10 minutes of use, and adjust back to a clearance of 3 mm as required. Oil the chain after every 10 minutes of use Direction of rotation of the chain. Do not touch chain at the chip ejection point. Residual risks Additional residual risks may arise when using the tool which may not be included in the enclosed safety warnings. These risks can arise from misuse, prolonged use etc. Even with the application of the relevant safety regulations and the implementation of safety devices, certain residual risks cannot be avoided. These include:  Injuries caused by touching any rotating/moving parts.  Injuries caused when changing any parts, blades or accessories.  Injuries caused by prolonged use of a tool. When using any tool for prolonged periods make sure you take regular breaks.  Impairment of hearing. (Original instructions)  ENGLISH Health hazards caused by breathing dust developed when using your tool (example:- working with wood, especially oak, beech and MDF). Symbols on the charger The following symbols are found on your charger: Your charger is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the rating plate. [. . . ]  Once the chain tension is correct, tighten the screws (16). When the saw chain is new, check the tension stretches slightly. Oiling the chain The saw chain must be oiled before each use and after cleaning using only the correct grade of oil (cat. Oil the whole saw chain (7) evenly using the applicator (9). [. . . ]